Precautions for the installation of solar street lights

Before installing solar street lights, there are many details that need to be paid attention to. These details include the buried parts of the street lights, the placement of the battery, the choice of solar controllers, the type of solar panels... These details seem inconspicuous but are actually very important. The first is the embedded parts: whether it is a street lamp or a steel structure or a communication tower... all objects rising from the ground need embedded parts as a foundation. There are two kinds of embedded parts for street light poles, one is prefabricated and the other is cast-in-place, prefabricated. As the name suggests, it is prefabricated and ready-made. The cast-in-place method is to dig the foundation pit and place the anchor cage into the pit and fill it with concrete. If these two types of embedded parts are constructed according to the normative method, their firmness is hard to distinguish. But the author strongly recommends that it is better to choose cast-in-place. The reason is very simple. Few construction teams can standardize the prefabricated embedded parts. There are many cases of light poles falling apart due to incomplete compaction. The placement of batteries: When installing solar street lights in northern areas, the batteries are habitually buried in the ground. In fact, this is very unreasonable. Not only is it easy to be stolen but also difficult to maintain. Usually the solar batteries are buried on both sides of the embedded parts, and the pits are not dug very deep in order to save trouble. This is nothing but to create convenient conditions for the thieves and make it easier to steal. Some villages have been selected as model villages for new rural construction, and both sides of the streets have been covered with cement, so that the battery is not easy to lose, but what if there is a problem with the wiring or the battery is broken? Do I have to smash the cement and put it back after repairing to restore the cement surface? This project is not small. If the battery is designed on the light pole, it will be much more convenient, that is, it is not easy to be stolen, and maintenance and replacement are also very convenient. Controller selection: There are many types and brands of solar street light controllers, so I won’t introduce them one by one here, as long as they are integrated (integrated refers to the automatic identification of LED lamps in series and parallel mode, debugging current and time can be used Remote control settings), there are many brands, recommend one-Guangdong Shuori, this brand of controller is good and practical. Solar panels: There are two main types of solar panels, one is monocrystalline silicon and the other is polycrystalline silicon. Monocrystalline silicon panels of the same wattage are more expensive than polycrystalline silicon panels because of its higher energy efficiency conversion. The deep differences are not elaborated here, because everyone may not understand it. Below are the appearance pictures of the two battery panels. Before installing solar street lights, we must make every detail in place. Only by doing so can we ensure the best use effect.