Common high street lamp is also belong to one new energy street light lamp type, called it a high lamp.
Because it was usually at 15 meters high above, a lot higher than other regular street light, therefore the name.
{high lamp manufacturer
。
jschindo。
com}
High street
ordinary high lamp is one of the new energy street light, so called high lamp.
This is because it is usually more than 15 meters high, much higher than other traditional street lamps, hence the name.
High lamp manufacturers (
{
。
jschindo。
com}
)
The characteristics of high lamp mainly reflects in: high;
In this world, people often say they stand high and see far, it is also of high lamp sympathy, but they need to do a small change, this sentence both;
The tall, over far;
。
Height is one of the bright light, rather than highlight advantages, because of the advantages of high can make the light source on the top of the light pole lighting area reaches perfection, so as to achieve ideal lighting effect.
However;
Born in Sri Lanka, destroyed in Sri Lanka;
This sentence here no, because of its advantages in often contain unknown faults.
For large semi-trailer, the shortest high lamp is too long, because the length of the semi trailer only 13 meters, the shortest growing will highlight 2 meters of above, this is absolutely not allowed.
Considering the production, transportation, installation and so on many disadvantageous factors, high lamp production finalized multi-segment assembly, convenience of transportation, is advantageous to the production and the production, kill two birds with one stone.
On the surface, the manufacturing method is very reasonable, but in the actual installation is not the case.
For example, if the customer order 30 meters high street light, high lamp manufacturers in shandong during manufacturing design of two parts, one part is 15 meters, another part is 15.
5 meters.
Outsiders may be curious.
Obviously, it is a 30 m long pole, is a period of 15 m, another is 15.
5 meters.
Yes, it's a good question.
The total length is 30.
5 meters, but after assembly is not 30.
5 meters, but 30 meters, because the light is composed of two segments, including 50 centimeters is inserted into the part.
However, from production to installation, high street lamps need to face many links affecting assembly size, such as rod winding, alignment, hot dip galvanized, welding, transportation and so on.
These links will largely influence the final depth of the plug-in, namely before the production design drawings, design depth of the plug-in to 50 cm, when actual installation for 40 cm or 70 cm, it is entirely possible.
It is also a consumer misunderstanding of the main causes of high lamp manufacturers.
When many customers check and accept high street lamp, measuring the size of the do not agree with the drawings.
The phenomenon in more than 30 meters high street lamp stand out, because more than 30 meters high street lamp by at least three to four parts.
For four parts, will have three plug-in points in four parts.
If each error of the insertion point to 40 cm (
Some even higher)
The sum of three parts as 1.
2 meters, the final height lower than this drawing requirements.
However, the customer may make the mistake of thinking that high lamp manufacturers are cutting corners, this is, in fact, due to the large insert error caused by deep insertion.
