What Is Indoor Led Light Fixtures?

In urban road, traffic is very much, the lighting environment is relatively complex, is also very strict to the requirement of lighting, street lamp installation or replacement of process, the correct selection of led solar street light is a very important thing.

Lost the use of electricity supply, solar street lamps to save the expenditure of the larger country, so that save a lot of the cost of electricity, and for solar led street light, in the cost of the maintenance cost is less.

Led solar street lamps are now using lithium battery, small, convenient, quick, energy-saving fixed directly below the solar panels, directly on the led street lamp behind the head inside, improve the coefficient of its safe use.

Led solar street light is a use of the resources of nature, through the sun's heat to power supply, storage battery and then provide the lighting.

In the process of purchasing the led solar street light, if we want to ensure that its brightness, not covet petty gain of, lead to the brightness of the led solar street light to reach the demand of the actual effect.

Want to learn more industry information or ask price, can call advisory

Required to tell the truth about scenery complementary street lamps use is to according to the practical usage of the configuration, it should have the choice of high level and performance requirements, the requirements of other conditions.

We were usually choose must fully consider the actual requirements.

But some users know the actual use of their requirements, why purchase use scenery complementary street lamp still can not meet the actual requirements?

This is reflected in the scenery complementary street lamp product quality problems, although there are a lot of scenery complementary street lamp manufacturers, but the quality of the product can't pass the number of manufacturers are not few, using solar scenery complementary street lamp can not meet the actual demand, because manufacturers often use low-cost approach to sales, product in a short period of time may fail or even damaged, for the application of scenery complementary street light caused great negative impact.

Quality closes nevertheless scenery complementary street lamps are inferior steel, pipe diameter to wall thickness and so on, the surface using cold galvanizing, cause the wind resistance is poor, poor surface treatment process, can cause the problem such as short time plastic layer falls off, rub off.

These low-end products in use after a period of time, is in the configuration is damaged, can't work normally, and continue to reduce brightness, until death lamp.

Want to learn more industry information or ask price, can make free calls

Table: 2015 parts of photovoltaic power station construction scale of adjustment and increase the national energy commission on September 24, 2015

With the progress of technology, LED applications are shifting from the traditional indication and backlight fields to the lighting field, and the market space in the lighting field is very broad.
Guotai Junan's recent research believes that the current LED industry has benefited from the launch of the lighting market, which is ushering in a good historical scene and has entered a three-year long period of high prosperity.
In addition, mainland enterprises benefit from the comprehensive advantages of technology, cost and support, and will enjoy the LED manufacturing chain transfer premium. The ratio of supply and demand in the industry in 2014 was only 1. 04 (1. 1 is the safe water level)
, Close to the high level of industry history in 2010. At the same time, the supply side contracted significantly.
CSA Statistics show that at the end of 2013, the total number of MOCVD units in China was 1090, an increase of about 2012 units over 110, far lower than the industry growth rate and the growth rate of downstream application demand.
With the substantial export of subsidies, future expansion will be more rational. In addition, the demand side is fast.
The LED lighting market has entered a high-speed growth range of 15.
Take leading enterprises as an example. New orders will grow more than twice year-on-year in 2014, and the average growth rate of the industry will double.
Industry Chain survey shows that from the end of 2013 to the end of May 2014, chip prices fell within 3, far better than the market expectation of 10, and it is expected that there will be a structural price increase in the future.
In the medium and long term, as the mainstream size of the epitaxial wafer is switched to 4 inches, the chip size is reduced, and the light efficiency continues to improve, the chip profitability is expected to continue to optimize.
After the downstream application products have experienced the process of actively reducing the price and seeking the market, they have now dropped to close to the price of energy-saving lamps, and the subsequent price reduction space is limited.
According to the survey, 3WLED lights have fallen by 33 to 2 in the past year. 9 US dollars, only the same energy-saving lamp 1.
5 times, and domestic cost-effective products are close to the price of energy-saving lamps.
In the medium and long term, with the increase of intelligent and dimmable ratio, the added value of application end is expected to increase. Industry Chain survey also shows: 1)
The utilization rate of chip capacity continued to be full. Due to the failure to form enough new capacity in the short term, the supply of most varieties of chips began to be tight in the second quarter.
In order to seize the upstream resources, the downstream manufacturers have successively announced that they have signed a long-term order with the chip factory that does not lock the price for more than one year (History for the first time). 2)
The visibility of LED lighting orders has exceeded the historical 3 months, and the current orders have reached 8 ~ The level in October.
The whole industrial chain in the mainland is already competitive, benefiting from the comprehensive advantages of technology, cost and supporting, and will bear the heavy responsibility of LED manufacturing.
According to the survey, after the application has become an international manufacturing center, domestic chips have accounted for more than half of domestic applications, and it is expected to achieve a large share of overseas foundry.
LED manufacturing is expected to breed similar semiconductor foundry in the mainland-Oligopoly enterprises.
The leading enterprises in the related chip, packaging and terminal markets deserve to be paid close attention to: Sanan Optoelectronics, Liad, maoshuo power supply, Foshan Lighting, qinshang Optoelectronics, sunshine lighting, etc.

How LED lighting companies are welcoming the new era of OTO Under the setting of traditional channels, the main function of physical stores is sales. The number of lamps sold locally determines their survival. Limited by time and space, the sales of physical stores can only be traded within a few hundred square meters or at most thousands of square meters. This is not the case under OTO mode. Through OTO, companies can extend their tentacles to every corner of the world without having to wait in the store. When the cold bench of the physical store gets harder and harder, OTO companies have already received a large number of orders through the Internet. In view of this, physical stores must realize functional transformation in time to adapt to the needs of the OTO model. In the eyes of many manufacturers, the benefits of OTO are obvious, but it is also a double-edged sword-a huge impact on traditional channels. After many years of development, many companies have formed their own stable channels. The introduction of the OTO model may cause damage to them. As mentioned at the beginning, the worry-free, and Hongguang lighting, at the beginning of the OTO operation, it will also affect the dealers and Physical store sales have a big impact. In addition, a series of issues such as product structure, price system, and management will gradually emerge in the process of implementing OTO. In view of this, some experts even call the current road to OTO breakthrough in the lighting industry as the 'fight of trapped beasts'. The emergence of enterprises is in sharp contrast with the reality of immature models, creating the dilemma and confusion of OTO in the lighting industry. The online and offline linkage of OTO is not only a problem of order conversion rate, but also a problem of local service. After a customer places an order online, how to deliver it? How to install it? How to solve a product problem? At this time, the role of the physical store becomes prominent. The physical store will serve as an offline experience store under OTO, providing consumers with more detailed services. The offline experience store not only saves consumers the logistics costs, but consumers can also pay after seeing the goods on the spot. If you are not satisfied, you may even return it for no reason. If the product is damaged in the logistics process, the staff can go to the door for identification, repair or exchange in time. Therefore, besides service, it is also service. The maturity of the OTO model will be concentrated on the breadth and depth of services. In the future, commerce will become a large service industry centered on communication, communication, interaction, logistics and transportation, installation, maintenance, and cleaning. Traditional trade profits will become lower and lower, and the profits of large services will become higher and higher.