Which street light

With the continuous development of solar technology, solar street light products is more and more popular, many rural areas are installed solar street light, but many issues should pay attention to install solar street lamp, especially in the select installation location and embedded foundation, a lot of people are not

with the continuous development of solar technology, solar street light products is more and more popular. Many rural areas have installed solar street light, but when installing solar street lights are a lot of matters need to pay attention to, especially when choosing installation position and embedded foundation, a lot of people won't notice, leading to poor solar street lamps use effect. So, when choosing installation position and base, we should pay attention to what?

the, installation location choice installation location must have enough light throughout the day, and must be no obstacles, to ensure that the installation location far from the tree. In the high-rise building solar panels and other obstacles can stop the sun, must not have a direct light source. Otherwise, the street lamp system will be unable to work normally. Solar street lamps must be far away from heat source. Otherwise, the service life of the battery will be greatly reduced. Solar energy lamp posts must be pouring on the basis of strong enough on clay layer. If the installation location is sand, and other atypical permafrost soil, please inform us in advance, in order to take targeted measures. Solar panels must be toward the south, the south and ensure the installation site, without any obstacles. two Foundation construction in order to ensure the internal measurement nut screwed to the threaded end, should be the length of the solar energy light pole flange reserve enough, to ensure that the four bolts in the same level. Is recommended to use level test and after assembly, use tape to protect the upper thread, in order to prevent the cement plug threads. 3. Install base according to the solar street lamp manufacturers provide foundation drawing for foundation pit excavation. At the same time, the concrete can be prepared. Put foundation cage in foundation pit, placed in a level to ensure that the basic carrier, and compact foundation cage. Again, make sure that the anchor bolt thread tape at the top of the protection, based on pouring concrete and keep the cage. Suggested that the concrete cover only a fixed plate and the nut, in case of rust. Clean the top of the foundation, and erased it. 3 - Seven days later, after the concrete curing and drying completely remove isolation plate/brick. These are matters need to pay special attention to when installing solar street light. When installation, it is important to note that in order to avoid presents the phenomenon which is not bright or lighting effect is not good.