What to do if the lamp holder of the landscape lamp fails

1. A small amount of damage u003cbru003eIf only one or two lamp beads are broken, we can repair them by these two methods: u003cbru003e1. Find the broken lamp bead, connect the metal at both ends of it with a wire, and short-circuit it. The effect of this is that most of the lamp beads can light up normally, only the broken individual lamp beads do not light up, which has little effect on the overall brightness. u003cbru003e u003cbru003e 2. If you have strong hands-on ability, you can go online to buy the same model of lamp beads (a large bag of ten dollars), and replace it yourself-use an electric soldering iron (a hair dryer will also work for a while) Heat the bead until the glue on the back of the old lamp bead is melted, then remove the old lamp bead with tweezers (don't use your hands, it is too hot) At the same time, install the new lamp beads while it is hot (note the positive and negative poles), and you're done! u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003eTwo, massive damage u003cbru003e u003cbru003e If a large number of lamp beads are damaged, it is recommended to replace the entire lamp bead board. The lamp bead board is also available online, please pay attention to three points when buying: u003cbru003e u003cbru003e u003cbru003e 1. Measure the size of your own lamps; u003cbru003e u003cbru003e u003cbru003e 2. Be optimistic about the appearance of the lamp bead board and the starter connector (explained later); u003cbru003e u003cbru003e u003cbru003e 3. Make a note of the output power range of the starter (explained later). u003cbru003e u003cbru003e u003cbru003e These three points of the new lamp bead board must be the same as the old lamp bead board-replacement of the lamp bead board is very simple. The new lamp bead board is fixed with magnets. When replacing it, remove the new lamp bead board and connect it to the connector of the starter. u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003eThe launcher is damaged u003cbru003eMost of the LED lamp failures are caused by the starter. If the lamp is completely off, or the lamp flickers after being turned on, the starter is probably broken. u003cbru003eThe starter cannot be repaired, so it can only be replaced with a new one, but the new starter is not expensive. Pay attention to three points when buying a new launcher: u003cbru003e1. Pay attention to the appearance of the connector-the starter connector looks as follows (if the starter is male, the lamp bead board is female; vice versa) u003cbru003e2. Make a note of whether your lamp can change color and several colors. The number of discolorations of the new starter must be the same as the old starter. u003cbru003e3. Remember the output power range of the starter-a range will be marked on the starter, as long as the power of the lamp bead board is within this range u003cbru003eIt is still very simple to replace. First, separate the starter from the lamp bead board. The starter is also fixed on the base with screws, just take it off. The new starter is also a magnet, just suck it and connect it to the lamp bead board.