Now the construction of urbanization, many village building development, and community is often used in modelling rich garden light, therefore the courtyard lamp sales soar. But the courtyard lamp in installation, courtyard lamp manufacturers today small make up take you to understand the courtyard
today, as the urbanization construction, the development of many residential buildings, often appear all sorts of modelling of rich garden light in residential areas, so the courtyard lamp sales surge. However, courtyard lamp installation and construction is not specification. Today, garden lamp manufacturers of small series will show you the garden lighting installation and construction of common problems. 1. Construction quality defects caused by the poor quality of construction accounted for a significant proportion. Main performance: one is the cable trench depth is not enough, not according to the construction standard sandbags brick; 2 it is aisle pipe production and installation does not conform to the requirements of both ends not according to standard production into a tube; The third is to drag on the ground when laying cable; Fourth, without the basis of embedded pipe according to the requirements of standard construction, mainly because the embedded pipe is too thin, plus bending to a certain extent, it is difficult to wear cable, appear in the bottom of the base; Bending of death; The situation; Fifth, thread and pressure to the thickness of the insulation package is not enough, and run for a long time can cause a short circuit. 2. Material is not enough from the perspective of the failure of treatment in recent years, low material quality also has a lot of factors. Main performance is less wire aluminum content, lead hard, thin insulating layer. This kind of situation is more common in recent years. 3. Support the quality of the project is not too difficult garden light cables are usually laid on the sidewalk. The pavement construction quality is poor, ground subsidence, lead to deformation of cable, cable armoring. Northeast China is located in the cold area, in particular, with the arrival of winter, the cable and the soil to form a whole. Once the ground sinks, it will be at the bottom of the garden light foundation, when the summer have a lot of rain, it will be burned in basic roots. 4. On the one hand, the unreasonable design overload it. With the continuous development of city construction, garden lamp is also growing. When a new garden light is built, it is usually connected with courtyard lamp near it. In addition, in recent years, the advertising industry has developed rapidly, advertising load also correspondingly connected to the courtyard lights, cause the garden light load is too large, cable head overheat, insulation, heat, grounding short circuit. On the other hand, the design of the light pole only consider their own situation, ignored the cable head empty space. Cable head coil, most can't even close, sometimes the cable length is not enough, joint building does not conform to the requirements, this is also the cause of the failure.