What is in the winter of photovoltaic power generation to reduce?

Many installed photovoltaic partner found home photovoltaic power station capacity to reduce a lot of, looking for small English reflect the problem. During the spring and autumn in fact need not too nervous, photovoltaic power station power generation peak, winter is the low season photovoltaic power station power generation. In addition to winter day

many photovoltaic installation partners found that their home photovoltaic power station output dropped sharply. They require little English reflects the problem. In fact, there is no need too nervous. Spring and autumn are the peak period of photovoltaic power generation, photovoltaic power generation are out of season in winter. In addition to the winter sunshine time is shorter, winter sunshine weaker and less photovoltaic power generation, these factors also nots allow to ignore: 01 haze and dirt due to the hot, dry weather, the winter air dust content is more than other seasons, winter haze weather than other seasons. Absorb and reflect the light in the suspended substances in the air, which leads to the surface of the module receives the sun down significantly. Weather lasted for a long time, if the smoke particles found on the surface of a pv module will accumulate and the module cover is formed on the surface, cause pollution of the surface of the battery module and further reduce the electricity. Keep the panels clean not only can improve the output, but also can effectively maintain pv module, because long-term accumulated particulate matter quality can lead to module produces a large amount of heat, cause hot spots, the service life of this could threaten module, or cause a fire. Snow snow module, only a small portion of solar energy photovoltaic module through the snow exposure, which affect photovoltaic power generation. For the Suggestions to install photovoltaic power station in yi snow area large Angle of photovoltaic panels installed solar panels within the scope of the good Angle to large Angle installation, can reduce the accumulation of snow speed, avoid the clearing trouble from time to time. When installation, keep a certain distance with the ground. In this way, will not slide down the snow accumulation at the bottom, so the snow will pile up and slowly to cover the entire component. How to maintain the pv power station after a general advice don't wait for the snow is too thick to cleaning, so as to avoid freezing parts. Hot water cannot be used for irrigation of photovoltaic panels, uneven heating and cooling can severely damage the photovoltaic panels. Soft objects can be used to push the snow down, be careful not to cut glass, because it will decrease the amount of light transmission. ( Bounce gently with the tennis on the tilt of the photovoltaic panel, let the snow slide down, this is a good way ~) Component has a certain capacity, but not on the top of the parts cleaning, it will result in the crack of the parts or damaged, affect the service life of parts. Snow removal must be clean and the snow bar should not be underestimated. Blocked part failure, will cause the entire photovoltaic panels to reduce power generation efficiency significantly. In addition, the reflection of the snow slightly promote photovoltaic power generation. If the snow does not cover parts, the snow on the ground like a mirror reflecting sunlight, thus increasing output.