Too Yang street lamp remote control to street lamp conventional design specification

1) New rural solar street light lamp spacing design LED lamps to light type lamp holder, sectional type optical reference to national standards for the direction of the maximum intensity of lamps and lanterns of lamps and lanterns and lamps and lanterns down vertical axis Angle between 0 - Between 65 °, lamps and lanterns of maximum intensity projection direction and perpendicular to pay



( 1) The new rural [solar street lamps Solar street light is a crystalline silicon solar battery power supply, valve control type sealed and maintenance-free battery ( Gel battery) Store electricity, super bright LED as light source, lamps and lanterns and controlled by the intelligent charging and discharging controller, is used to instead of the traditional public power lighting lamps. 】 Light spacing design LED street light head 【 LED street lamp head namely semiconductor lighting, light emitting diode as light source, because it is a kind of solid cold light source, green pollution-free, less consumption, high luminous efficiency, long service life, etc. 】 Belong to the sectional type light lamp holder, sectional type light with reference to national standards for the direction of the maximum intensity of lamps and lanterns of lamps and lanterns and lamps and lanterns down vertical axis Angle between 0 - Between 65 °, lamps and lanterns of maximum intensity projection direction and the vertical Angle should not exceed 65 °, the theoretical design lamp spacing = tg65 x light pole height x 2, according to the characteristics of the new rural construction a slight difference, but the gap is too big. （ 2) The design of lamps and lanterns, A) Reference to pick on the arm of the national standard of lamps and lanterns should not be more than a quarter of the installation height of if pick spent long arm length, it is can reduce the brightness of the lighting side kerbstone and sidewalks ( Intensity of illumination) ； Second, high mechanical strength requirements of cantilever, and may be the cause of lamps and lanterns and light source vibrates, affect their service life, third, affect beautiful, causing the cantilever and the ratio between light pole not harmonious, four is cost will increase, so the cantilever length shoulds not be too long. （ 2) Increase the Angle of lamps and lanterns should not be more than 15 °, the elevation of lamps and lanterns, although will add to the amount of reach the opposite side of the road lighting lamps and lanterns, can surface brightness will not significantly increased; Special way conventional lighting lamps and lanterns to decorate a few basic rules using conventional lighting system should meet the requirements, on the corner, if the elevation of lamps and lanterns is too large, produce the possibility of glare will increase, it also will increase. So the elevation Angle of lamps and lanterns also should be limited. （ 3) Light pole shall be located in dangerous places or maintenance serious blocking traffic. （ 4) The new rural construction road, the average illuminance appropriate for 15 lx at night, and should provide appropriate vertical illuminance 【 Vertical illuminance ( 垂直照度) On the surface of the vertical illuminance. 】 。