The solar wind street light1

Common solar garden light controller on the market at present basically there are three indicators to represent the working state of each component in shandong today solar street lamps factory small make up to you to introduce how to judge through the analysis of the solar garden light controller to

common solar garden light controller on the market at present basically has three indicators to represent the working state of each component. Today, solar street lamp manufacturers in shandong small editor will show how to analyze and judge solar garden light controller failure. One, the light is described during the day, solar garden light controller will be charging in the sun light up the red light, The sun) ( For the stroboscopic illumination way, the stronger the sunshine, the greater the charging current, the faster the stroboscopic) ； Among them, in the middle of the double color lamp ( 蝙蝠) On behalf of the capacity of the battery, the red light said the battery to discharge have been yellow light said battery undervoltage, green said everything is ok. Said another red light led working status: normally on said the battery to discharge normal fault stroboscopic said. Second, the phenomenon of fault indicator and 1. During the installation, the led light source will not extinguish ( Double color lamp for the green, red light led work) When this happens, we need to check the wiring is correct, because if the solar garden light controller is not received solar panels transmission voltage, the default led would be in a working state, until the end of the set of working time. This will also cause it doesn't work the next day. We need to check whether the connection between the controller and solar panels. Another reason is that solar panels are direct short circuit ( Because of the high power panels will be diode protection, and this side can be shortened to make it work normally) 。 2. Solar garden light use after a period of time not bright, Double color light red) When the solar garden lamp controller in the middle of the light red, said the led light source has been discharge, it will automatically cut off the led light source. By default, only after the battery voltage to discharge protection voltage, light emitting diode light source to continue to work. 3. In the evening, the led light source for a time not bright, Double color light yellow) Double color light yellow voltage is too low, usually appears after the long rain. When it open in the evening for a period of time, it will stop working. Street lamp factory lighting led street lamp factory maintain after-sales service way is to disconnect the led light source line, let the sun charging for a day or two to work properly, Of course, don't put the line to collect) ； Solar garden light controller will protect the battery. 4. Light is not bright, Double color lamp not bright red indicator is on or two) If you don't bright led light source, the first thing to see the lights of the controller. If the controller is damaged, the working state of the indicator light will be incorrect. Judge fault, using the light on the solar garden light controller is shandong street lamp factory led lighting lamps and lanterns manufacturer in maintenance after one of the basic skills of the solar garden light. In addition, we also need some other tools to judge other problems.