The led lamp

Solar panels matters needing attention: do not install the solar panel component in a cool area such as trees or buildings. Please do not place near open flame or flammable substances. The assembly structure should be able to adapt to environmental requirements. Please select the appropriate materials and anti-corrosion treatment. Must start with



solar panel notice:

don't install solar panels components in the shady area such as trees or buildings. Please do not place near open flame or flammable substances. The assembly structure should be able to adapt to environmental requirements. Please select the appropriate materials and anti-corrosion treatment. Must be installed in the form of solid components, components may fall from the sky, which will result in financial loss. Component will not be hard disassembly, bending or impact, so as to avoid dangerous operation, such as stamp on components.

spring washer peace washer must be used to reduce the panel component to lock in fixed on the bracket. Solar panel installation optimization into 30 degrees with the sun, and panel components according to the environment and the support structure of the state assembly wiring in the proper manner.

panel components should be properly connected in the junction box of the positive and negative. Output circuit should be properly connected to the equipment. Don't make the positive and negative short circuit, to ensure that there is no gap between connector and insulation joint. If there is a gap, which sparks street light or electricity.

it is important to check whether hoisting structure falls off. If necessary, tighten the parts and check each parts, wire, the bottom line and plug the link state.

must be inspected component surface with a soft cloth. If change the panel component ( Usually do not need to change 25 years) , you should choose the same type of the same type of component. Please do not touch the cable connector. If you need to use safety equipment ( Such as insulating gloves) 。

repair component, please use opaque objects or materials cover components surface, because components under strong light can produce high voltage, it is very dangerous. Components of warranty for 3 years, components of power attenuation is not more than 10% within the next 10 years, 20 years less than 20%.