The advantage of high lamp in design1

Light is called high lamp, because he was tall and have lifting system, follow the below high lamp manufacturers to look at.

high lamp by an electric motor, hoist, electric hoist system of three sets of hot dip galvanized control wire and cable, etc. Light pole installed inside body, lifting speed of 3 to 5 meters per minute. Set 6 - high lamp lighting electrical system 24 lamps of 400 w, 1000 w metal halide ( The white light) , cast light, floodlight, computer control device can automatically control drive to turn off the lights when time and partial or full illumination.

high lamp base concrete surface roughness is less than 5 mm/m try to keep the vertical bar embedded parts level. Embedded parts below ground around 20 ~ 30 mm flange plate, reoccupy C25 fine stone concrete cover, the strengthening rib in order to prevent the water. Embedded parts above the anchor bolt flange thread wound good for damage. According to the installation drawing of embedded object positioned properly monitoring poling embedded parts, to ensure that the arm rod out direction (perpendicular to the driveway Or in accordance with the requirements of engineers) Anchor bolt as the main reinforcement.

high lamp lighting manufacturers should use attachments, low power consumption, stable performance, energy saving technology and equipment, a reasonable choice in the guarantee of high lamp lighting effect at the same time, should prevent the light pollution of lighting industry, limit high lamp light pollution to give priority to in order to control and avoid the phenomenon of treatment after pollution.