Street lamp light, solar street lamps skin line operation steps

Solar street light is a lighting device can be used in urban streets and parks, but also can be used in population distribution density is small, inconvenient transportation and economy is not developed, difficult to use conventional energy to generate power, so when installing solar street lamp stand leather line



the solar street light is lighting can be used in urban streets and parks, at the same time also can be used in population distribution density is small, inconvenient transportation and economy is not developed, difficult to use conventional energy to generate power, so when installing solar street lamp stand skin line operation process is what?

1 skin, make skin line insulation should be adopted when the line, if it is a copper core cannot be less than 1. 37 mm, and if it is aluminum core is not less than 1. 76 mm;

street lamp factory 2, make skin line overhead conductors joints should be symmetrical on both sides of the pole to take it away from the rod centre 400 - 600 mm, both sides need to agree, this is vertical line to connect power lateral approach;

3, solar street light skin line if more than four metres long, need to add support among fixed, using no less than 7/1. 0 insulation wire, and use the standard method of single cross tie to tie;

4, when the lines and vertical lines for different metal, and application of cable tie as a transition joints as a jump line, the longest jump line is less than 100 mm, and make skin line should do tie line in insulation support in the back, can't use this line to entangle, and in the power cord out of the gray iron pipe or hole should add plastic pipe, shall not be less than 200 mm long;

5, vertical line volley period of up to have a joint, joint to wrap around 5 - on each side 7 laps and package tape, different specifications of joint cannot be docking, and wear into the iron tube and rod hole inside the power cord, can't have a joint, vertical line at the same time can't through the high tension line between;

6, high-voltage wire close of variable length line, need to be 7/1. 0 insulation wire, with the main joint back button with the binding wire winding should be the other 30 ~ 50 mm;

7, solar street light vertical line to fasten, tidy and suitable for broken skin dew bare wire should be replaced, and meet the household vertical line and the line in the biggest swing, the distance of not less than 50 mm, there are vertical lines to connect power jump line in the construction, maintenance, need pliers with tight;

8 each line pressing bolts, capacitors, ballast, maximum pressure of two threads, thread the bending direction should be clockwise and flat mat compression;

9, the zero line of the solar street lamp stand line prohibited lines to meet the household with the user of the zero set together, prevent the zero line jumped informant zero line disconnected, from the supply power from the users table.