Summer is a Taiwan typhoon season, and light, generally more than 15 meters high, so much affected by the typhoon. General lift high lamp before the typhoon comes down the light at the end of every dish. Under high lamp manufacturers tell your brother about doing so what is the reason for the
the summer is the season of typhoons, the height of the light, generally above 15 meters, so is highly affected by the typhoon. In general, lifting high lamp light board should be down before the typhoon comes. The following high lamp manufacturers will tell you the reason for doing this. High lamp light pole and the lamp of the feet is designed to resist the typhoon wind 12, therefore, after the typhoon, lamp light pole and feet are generally safe and reliable. However, high lamp light panel is different. High lamp light panel pulled by wire rope, flat on upper part of the light, supporting frame, relying on its own gravity stable equilibrium state. Usually, when the wind is not big, can keep the balance, to ensure that the lamp panel is not damaged. Once the typhoon comes, lamp panel will be out of balance, under the action of strong wind, strong to collide with the light pole, the lamp panel, lamps and lanterns and varying degrees of damage steel wire rope, loosen the connection parts fasteners in different degrees, causing all kinds of potential safety hazard. At the same time, this kind of collision may lead to lamps and other equipment installed in the lamp on the plate and the attachments, hurt innocent people, may also cause falls off lamp plate, cause more damage. Therefore, before the typhoon comes, should reduce the high lamp panel. In this way, not only can eliminate the above all kinds of potential safety problems, also can to light, to conduct a comprehensive inspection, the lamps and lanterns and wire rope can be reinforced at the same time, replace the aging accessories, for parts of the safe hidden trouble, etc. To ensure that the light is in good working condition.