Solar street light skin line lamp factory operation steps

Solar street light is a lighting device can be used in urban streets and parks, but also can be used in population distribution density is small, inconvenient transportation and economy is not developed, difficult to use conventional energy to generate power, so when installing solar street lamp stand leather line operation



the solar street lamps Solar street light is a crystalline silicon solar battery power supply, valve control type sealed and maintenance-free battery ( Gel battery) Store electricity, super bright LED as light source, lamps and lanterns and controlled by the intelligent charging and discharging controller, is used to instead of the traditional public power lighting lamps. 】 Is lighting can be used in urban streets and parks, but also can be used in population distribution density is small, inconvenient transportation and economy is not developed, difficult to use conventional energy to generate power, so when installing solar street lamp stand leather line what operation process, the following will follow yingli solar street lamp manufacturers together to look at: 1, make skin line insulation should be adopted when the skin of the line, if it is a copper core cannot be less than 1. 37 mm, and if it is aluminum core is not less than 1. 76 mm; 2, make skin line overhead conductors joints should be symmetrical on both sides of the pole to take it away from the rod centre 400 - 600 mm, both sides need to agree, this is vertical line to connect power lateral approach; 3, solar street light skin line if more than four metres long, need to add support among fixed, using no less than 7/1. 0 insulation wire, and use the standard method of single cross tie to tie; 4, when the lines and vertical lines for different metal, and application of cable tie as a transition joints as a jump line, the longest jump line is less than 100 mm, and make skin line should do tie line in insulation support in the back, can't use this line to entangle, and in the power cord out of the gray iron pipe or hole should add plastic pipe, shall not be less than 200 mm long; Line 5, volley period of up to have a joint, joint to wrap around 5 - on each side 7 laps and package tape, different specifications of joint cannot be docking, and wear into the iron tube and rod hole inside the power cord, can't have a joint, vertical line at the same time can't through the high tension line between; 6, the high voltage wire close variable length line, need to be 7/1. 0 insulation wire, with the main joint back button with the binding wire winding should be the other 30 ~ 50 mm; 7, solar street light vertical line to fasten, tidy and suitable for broken skin dew bare wire should be replaced, and meet the household vertical line and the line in the biggest swing, distance of not less than 50 mm, there are vertical lines to connect power jump line in the construction, maintenance, need pliers with tight; 8 each line pressing bolts, capacitors, ballast, maximum pressure of two threads, thread bending direction should be clockwise and flat mat compression; 9, the zero line of the solar street lamp stand line prohibited lines to meet the household with the user of the zero set together, prevent the zero line jumped informant zero line disconnected, from the supply power from the users table. Above is the solar street light skin line operation steps, if you have any questions can call our factory, our company is a professional manufacturer of solar street lights, quality and low price, welcome to call us.