Solar street light component packaging need to pay attention to what problem

Purchase solar street light, the district is different, some in remote areas, so in the course of carriage, for some large, such as street lamp light pole, to need to notice all the more. So, for that, now the solar street light for you to sort out some content, and

purchase solar street lamp, different areas, some in remote areas, so in the course of carriage, for some large, such as street lamp light pole, to need to notice all the more.

so, as such, solar street light for you to sort out some content now, hope I can help you.

solar street lamps with a width of 60 cm of the gas film mat lamp arm components, gas film mat must be 60 cm. Gas film mat part for its pressure to one 6 of the width, is divided by 10 60, equal to 10 cm, gas film mat need power joint tape winding 3 laps, winding to exert oneself to do STH. But don't too hard, and the tight of twisting, then the rope winding, spacing of 80 & plusmn; 10mm。

will then only after completion of assembly and debugging of the lamps and lanterns in the original packaging box, first clean dishcloth plug box. Wipe the dust particles. Then sealed boxes with a dynamic adhesive tape. The sealing everyone please note, solar street lamps use dynamic tape first sealed in the middle of the wooden case, according to the tape with one hand, a hand tape, and then with good sealing tape vertically front cover, to ensure foolproof. Power on both sides of the tape is 80 mm from the top edge, position in the middle of the package, remember in the middle, everyone don't seal slanting. Otherwise the effect is good. Required power tape end face flush, the position is correct. With baling press finally ends in cases 200 & plusmn; 20 mm in each play a circle packing tape. According to the tight.

with marker on the sign finally fill in the product model and quantity, will sign on the solar street light boxes long surface center position.