Solar street lamps of 90 w lamp installation steps

Yangzhou detail yingli solar street lamps and lanterns installation steps: 1, for each part component is fixed: solar panels fixed on the bracket of solar panels, lamp holder to carry on the arm, then stent with arm fixed to the main stem, and wear the cables to control box



yangzhou yingli detailing the solar street lamps Solar street light is a crystalline silicon solar battery power supply, valve control type sealed and maintenance-free battery ( Gel battery) Store electricity, super bright LED as light source, lamps and lanterns and controlled by the intelligent charging and discharging controller, is used to instead of the traditional public power lighting lamps. 】 Lamps and lanterns installation steps: 1, for each part component is fixed: solar panels fixed on the bracket of solar panels, lamp holder fixed to carry on the arm, then stent with arm fixed to the main stem, and wear the cables to control box 【 The control box is used widely. 】 ( Battery box) 。 2, light pole before operation, each part of the first check fasteners, lamp holder to install whether correct, light work is normal. Then work in simple debugging system is normal; Loosen the solar panels on the controller cable, light work; Connected to the solar panel cables, light; Careful observation of each indicator light on the controller changes at the same time; Everything is normal, before lifting the installation. 3, the main light pole lifting, pay attention to safety; Screw fastening absolutely good, sunrise Angle deviation, such as the component needs to adjust the direction of the sun completely up to end toward the south. 4, put the battery into the battery box, according to the technical requirements will be connected to the controller; Connect the battery, and then pick up the load, and then answer the solar panels; Connection operation is important to note that each terminal with indicated on the controller cannot be wrong, plus or minus two polarity can't collision, cannot meet the; Otherwise the controller will be damaged. 5, the debugging system work is normal; Loosen the controller solar panels on the wire, the light; Connected to the solar panel cables, light; Careful observation of each indicator light on the controller changes at the same time; Everything is normal, can seal control box.