How the battery solar street lamps placed? Take out the battery box a ( Contain upper and lower body, sealing ring, fasteners, steel tube) Degree of the second half of the department of housing and be placed on the ground, take out the battery, put it gently on the battery box, which in turn opened tied to battery
the solar street lamps Solar street light is a crystalline silicon solar battery power supply, valve control type sealed and maintenance-free battery ( Gel battery) Store electricity, super bright LED as light source, lamps and lanterns and controlled by the intelligent charging and discharging controller, is used to instead of the traditional public power lighting lamps. 】 How to place battery?
to take out the battery box a ( Contain upper and lower body, sealing ring, fasteners, steel tube) Degree of the second half of the department of housing and be placed on the ground, take out the battery, the light in the battery box, in turn, open tied to battery wire line ( Or wire) And use tape to wire thread part wrapped up, prevent negative collision caused by short circuit. And then put a good seal, the two wire from the upper department threading hole wear out from inside to outside of box, and then cover cover, zhongshan new energy co. , LTD. Is engaged in the production design of solar street light, high lamp factory, 20 years production experience, solar street lamps to build the most professional manufacturer of solar street lamps,. , box good screwed up and down. Then traverse through the steel tube and steel tube set in the battery box threading hole in band 【 Clamp is connected with grooved pipe fittings, valves and piping accessories a connection device, used in tight coupling effect between the quick joint, the general two joint with gaskets, rubber, silicone and four fluorine. 】 Tightening. Note: A. Battery when placed in the battery box should take put down gently, to prevent the broken ground box. B。 Battery output line in any environment banned short sub, avoid damage to the battery. C。 Battery (between If you have two pieces of battery) Cable must contact is good, and the tape wrapped sealed, do moistureproof.