Solar street lamps factory have again good development market also to improve production technology dynamic | | industry lighting: the rural solar led street lamp manufacturers3

Guangdong yingli controller introduces, to buy back the lamps and lanterns, solar street lamps, don't busy installation, should look at the tag of lamps and lanterns and read the installation instructions, and according to the instruction of installation and use of lamps and lanterns, otherwise there may be dangerous. As far as possible when in the use of lamps and lanterns is not

those responsible for solar street lamps in guangdong province in detail, after buy solar street light lamp holder, and don't have to be busy installation, first should be careful to see lighting lamps and lanterns of identification and read the manual installation, and installation according to the requirement of the instruction, application of lighting lamps and lanterns, or is likely to produce risk.

main parameters according to the light source of present immediately changing embrittlement of leds, reddish found on both sides of the led lamp, led lamp black or have the shadow, leds jump not bright, should immediately changing led light tube, to avoid burning unsafe conditions such as electronic ballasts.

in the cleaning maintenance should pay attention to when don't need to change the structure of the lighting lamps and lanterns, also need not arbitrarily changing lighting lamps and lanterns of artifacts, in cleaning up after the maintenance, should be packed according to the original state will be lighting lamps and lanterns, lighting lamps and lanterns parts don't have to be short, wrong.

lighting lamps and lanterns also want to improve in the application of maintenance, can increase its life. House of leds will always scrub with wet cloth, and pay attention to avoid moisture penetration, appear in case time became long rust destroy or ZouDian short-circuit fault condition.

in the application of lighting lamps and lanterns, as far as possible need not frequently when the power switch, lighting lamps and lanterns in often starting moment, according to the tungsten wire electrical discharge is more than normal work when power flow, prompting tungsten filament temperature rise dramatically speed up the sublimation, which will greatly reduce its lifespan, so try to avoid lighting lamps and lanterns of the power switch. Recommended reading: how to distinguish the quality of the solar energy lamp LED lamps and lanterns