Solar street lamp lighting component packaging

Solar street lamps light pole component packaging 1) Pre wear thin wire will be 16 on the wire through the light pole component, and set aside 300 mm allowance on lampposts components at each end, will be on the bottom of the light pole of fine wire clamp wire bending a tick. 2) Wear sheath line will have prepared too

solar street lamp lighting component packaging

1) Pre wear thin wire will be 16 on the wire through the light pole component, and set aside 300 mm allowance on lampposts components at each end, will be on the bottom of the light pole of fine wire clamp wire bending a tick. 2) Wear sheath line will have prepared the solar cell component line ( Component red line at the end of the line after controller in advance with insulating tape paste insulation, insulation tape winding layer 2) Connect battery components end by skinning open 30 mm wire stripping pliers, to expand the wire line core through the wire core tight after returning, then with insulating tape and wire line core fixed firmly, twitch lampposts the wire component at the top of the line out and set aside 500 mm to 1000 mm ( According to lampposts component model) Components of the allowance will be on the bottom of the light pole end coil after tied with 200 mm cable tie and put on the light pole, on the top of the light pole on the light pole with the components of the line. Pay attention to in the threading process don't touch broken line. 3) Sheathed wire do logo on the light pole component sheathed wire from the lower pole of the strip length is about 200 mm leather sheath, and then on the solar battery components sheathed on both ends of the line to do the 'solar battery components' logo, at the same time must ensure that the logo is clear, LED street light, not easy to fall off.