Solar photovoltaic power station in winter snow removal should be paid attention to the problem?

Snow for photovoltaic power station and the influence of the above-mentioned effects similar to dirt, pervious to light quality is affected components, will affect the output performance of the cell. Often can see friends some drying out of the snow cover in the beauty of the photovoltaic power station, in fact,

snow's influence on the photovoltaic power plant similar to the above mentioned dust, dust will affect the components of light transmittance, will affect the output of the battery performance. Often as you can see, some of the people in the circle of friends bathed in the snow-covered photovoltaic power station in the beautiful scenery. In fact, they don't realize how much snow on the influence of the power station. If after snow accumulated on the parts with thick snow, the need to clean it, and you can use the soft object pushes snow, be careful not to scratch the glass. Parts have a certain carrying capacity, but can't trample on cleaning, it will result in the crack of the parts or damaged, affect the service life of parts. Suggestion: clean up the snow on the parts in time, don't wait for the snow is too thick to clean up, check the stability of the scaffold, to prevent power station collapsed. At the same time, the components of icing may also affect the service life of power generation and system. The points for attention during the snow removal of 1, must pay attention to the use of soft goods, prevent scratch glass, a reduction in the number of pervious to light the battery components; 2. Must be careful not to use hot water washing panels. Uneven heating and cooling can severely damage the panels. 3. Have to be careful not to step on the parts in cleaning them. Parts have a certain bearing requirements, this may result in the crack of the parts or damaged, affect the service life of parts. 4. Must be careful not to wait until the snow is too thick to clean, so as to avoid freezing parts. 5, snow removal must be clean, don't underestimate ice cream bar. If only a small piece of snow on the panels, should also be cleaned up, blocking panels of the failure of the whole, to reduce inverter power generation efficiency significantly. 6. Tap on a panel with sharp object is not appropriate, so as not to scratch even broken toughened glass. In addition, too much force will result in the crack of the photovoltaic cell components, affect the normal power plant. Snow removal tip: for small photovoltaic power station, before the snow can be a cloth or plastic cover panels, after snow, the panels can be solved. Strong winds when winter comes, is one more thing we plant installation and user especially easy to ignore. It is strong wind and heavy snow sometimes. We more than once raised the case of plant parts was taken by the strong wind. Shaw warned: flat power station on the roof needs attention. Macro photovoltaic advice: fixed timely inspection station stents in rain and snow season, to tighten the stent briquetting, check the attached cable wind rope, don't wait for the snow is too thick to cleaning, check the stability of the bracket, so as not to happen. At the same time, the components of icing may also affect the service life of power generation and system. Because of the cold weather in winter construction, some workers wear gloves to work, not convenient operation. Connections MC4 connector and cable distribution box, must pay attention to electricity safety.