【Solar Light Factory School】Do you know how to connect solar street lights?

Solar street lights are more and more widely used in road lighting. I believe everyone is already familiar with solar street lights. How much do you know about the installation of solar street lights? Have you connected the wiring method of solar street lights correctly? Let's follow the editor of the solar light factory to understand the wiring method of solar street lights and some small details that need to be paid attention to, and see if you install the solar street light wiring method right. First: Connect the positive and negative poles of the solar street light source to the controller respectively. Pay attention that the positive and negative poles cannot be reversed, and then wrap them with waterproof tape. Second: Connect the positive pole of the solar street lamp battery and the positive pole of the solar panel to the first red wire of the controller, and wrap it with waterproof tape. Third: Connect the negative terminal of the battery to the negative terminal of the controller and wrap it with waterproof tape. At this time, the idle light of the controller lights up, wait for about a minute, the discharge light is on, and the light source will light up synchronously when the discharge indicator light is on. Fourth: After the solar street light source is on, connect the negative pole of the battery panel and wrap it with waterproof tape. Within five minutes, the light source will automatically go out and the controller will enter the charging state. Do you know how to connect solar street lights? With these methods, no amount of solar street lights are afraid to install.