Solar Light Factory: How to achieve satisfactory lighting effects with LED street lights?

The installation requirements of LED lighting street lamps are based on the road section, width, vehicle and pedestrian conditions. Generally speaking, it can be symmetrically arranged on both sides of the road, staggered on both sides, arranged on one side, and suspended in the middle of the road. For roads and Yingbin roads with a width of more than 20 meters, symmetrical arrangements on both sides can be considered. For roads with a width of more than 15 meters, staggered arrangements on both sides can be considered, and narrow roads can be arranged on one side. In special places such as road intersections, bends, ramps, railway crossings, crosswalks, etc., LED road lights are generally installed to help drivers and pedestrians recognize the road conditions. In the lighting of sections inside and outside the tunnel and the transition section from urban streets to suburban roads, the adaptability of the driver’s eyes to changes in light must be considered. The power, installation height, and longitudinal spacing of LED street lights are important parameters for light distribution design. By combining these three factors, a satisfactory lighting effect can be obtained. LED street lights should use light energy reasonably to prevent glare. The light emitted by it should be irradiated along the required angle, and fall on the road surface in a designated pattern, with uniform light distribution, high brightness on the road surface, and low glare. In order to reduce glare, the light distribution can be controlled above the maximum light intensity. For more industry information or product prices, you can call toll free: 4000-760-286