Solar energy integration street lamp manufacturers

24 VLED: choose LED lighting, LED lighting, long service life, the light is downy, the price is reasonable, which can realize power regulation is very cold and cheerless, night time, is to save electricity, which can reduce the configuration panel, cost savings. Around 80 - per watt 105 lumens,

24 a light-emitting diodes: choose led lighting and led lighting, long life, the light is downy, the price is reasonable. Power regulation can be realized in the form of very cold and cheerless. In the evening, save the electricity consumption, so can reduce the configuration panel, and cost savings to be helpful. About 80 - 105 lumens per watt, remain below 5% or less; The 12 v battery ( Series of 24 V) : use lead-acid maintenance-free batteries, moderate price, stable performance. Solar garden light, 。 jschindo。 com) Is preferred. 12 v panels ( 24 v string) : 15% of the conversion rate is greater than the single crystal characteristics; 24 V controller: MCT charging mode, the work function ( Connection) ； 6 m light pole ( Good appearance, durable) 1. Solar garden light installation method is as follows: the solar panel is fixed on the solar panels, lamp holder will be fixed on the bracket of arm, and then use arm bracket in the main stem, and insert the cable control box ( A battery pack) 。 2. In lift light pole and check the fasteners and all parts, before being lamp holder installed correctly, the light work. Then, simple debugging system is working correctly; Loosen the control cable, gently operating solar panels. 3, the main light pole hoisting, pay attention to safety; Screw fastening absolute good, sunrise angular deviation is big, such as the component need to adjust the sun completely depends on the direction to the south. 4. Insert the battery into the battery box, and according to the technical requirements for its connection to the controller; Connect the battery, and then pick up the load, the solar panels. Join operation is very important. It should be noted that each terminal and the controller is marked as there are no mistakes, positive polarity and negative polarity not conflict, also can't meet. Otherwise, the controller will be damaged. 5, debugging, system working properly; Loosen the controller wires solar panels and light; Cable connected to the solar panels, light; Look carefully, controller change each indicator light at the same time. Everything is normal, control box can be sealed.