Signal light pole manufacturers share the signal light pole cantilever installation process

Signal light pole production increase in the number of signal light pole installed production transportation insurance, signal light pole production - below - Guangdong new energy to the detailed with you say signal light pole installation process: 1, after arrived at the scene, make full use of the mark

to install signal signal light pole lighting manufacturers, adds to the traffic safety. The following signal lighting manufacturers in guangdong new energy will introduce to you detailed signal light pole installation process: 1, after arrived at the scene, make full use of signs, railings and other safety facilities to pedestrian and traffic management, in strict accordance with the procedures of construction, in order to protect the passers-by and the safety of the operator, to prevent accidents as far as possible, to ensure construction safety. 2. Basic position is determined, the size of the according to the regulations of design drawings for foundation excavation at the specified location. Foundation after treatment by the regulation, build-up templates, binding reinforcement, pouring concrete. The location of the anchor bolt and base flange should be correct, and reach the specified level. 3. Mark the installation of the support structure should be the foundation concrete strength meet the requirements and approved by the supervision engineer. The mainstay of the flange plate and concrete foundation base flange plate should be level and close cooperation. The anchor bolts should be installed correctly. After tightening bolts, pillar can not tilt. 4. By sliding bolt, clamp under such as fittings will sign on the post. Pillar logo plate edge in distance from the edge of the shoulder should be keep in 20 centimeters, single column bottom edge of the sign board with the height of the road surface should be kept at 250 centimeters, cantilever installation network should keep off the empty road 5. 2 meters. 5. Sign after installation, check and adjust the signs of verticality and height, make it conform to specified requirements. 6. Mark cantilever installation layout should be perpendicular to the road centerline. Installation roadside post marks signal lamp control system, the layout should be vertical or and road center line at an Angle, direction and the warning signs of 0 ~ 10 degrees, prohibition and indication of 0 ~ 45 degrees, the line of sight guidance sign is 80 ~ 90 degrees. The above is the signal light pole installation process. Signal light pole manufacturers in guangdong new energy will arrange and release for you. Guangdong new energy co. , LTD is located in the northern suburb of historical and cultural city in guangdong JiGuo lighting industrial park. Welcome new and old customers to visit our company guidance.