Rural street lamps factory

Light, usually under 15 meters above 35 meters of steel conical light pole and high-power modular fixtures are composed of new type of lighting. It is made up of lamp holder, light, electric lamps and lanterns, rod body and basic parts. Light, scope of application is very wide, such as city square

high lamp is usually referred to by more than 15 meters below 35 meters steel conical light pole and high-power lamp holder of new type of lighting. It is made up of lamp holder, internal high lamp, electric parts, rod body and base parts. High lamp is widely used in city square, station, wharf, yard, highways, stadium and overpasses. High lamp lighting range, high brightness, has become an indispensable part of urban outdoor lighting, and was deeply loved by people. However, when high lamp manufacturer production, must meet the following production standards.

a, material standard, in the light of the light, open working environment, all steel parts, such as light pole, shall be galvanized, to ensure that the corrosion resistance of 30 years. Steel should be within the plug-in or flange, the installation site should be gradually welding, to eliminate hidden dangers. Aluminum oxide. Made of stainless steel and aluminum parts, and exposed to outdoor standard parts are all made of stainless steel. Electrical contact for brass or silver plated copper cathode, hanging stainless steel cable, and installed with existing national standards. Hot dip galvanized and passivation shall be not less than 80 microns. Second, the light, the light standard die cast aluminum housing, heat dissipation is convenient, effective control of temperature, prolong service life. Toughened glass vulnerable to sudden changes, has a thermal stability. Inside a smoldering and high-temperature lines. Into line with sealing device, effectively prevent moisture to enter. Protection grade reaches IP65 lamps and lanterns or above. Lamp holder can withstand the 30 m/s wind speed. 3. Light source standard high-pressure sodium lamp or high brightness led light source, the service life of 50000 hours, high efficiency, has the function of instantaneous trigger again, is usually 200 watts - 1000 watts, etc. The power supply voltage is 220 v. Four, the power factor standard should be equipped with power factor regulation of capacitor has enough capacity, make the line power factor in 0. 85 and 0. Between 95 ( Need special order) 。 For the above four standard, high lamp manufacturers must pay special attention to in production. Light is a large lighting lamps and lanterns. If the production standard can not meet the requirements, after installation may affect personal safety. Finally, if you can't satisfy the standard of the light source, light source will be easily damaged and not bright, so as to make the maintenance more trouble in the future.