Photovoltaic solar street lamps system of fuzhou solar street lamp installation contractor

The application of solar energy street lamp is more and more wide, a lot of friends is not clear how solar street lamp installation and construction, the following will tell my friends about solar LED street lamp installation construction scheme. The application of solar energy street lamp is more and more widely, many friends also not clear too

the application of solar energy street lamp is more and more widely. Many friends still don't know how to install and build solar street lights, so let's talk about solar LED street lamp installation and construction scheme. The application of solar energy street lamp is more and more widely. Many friends still don't know how to install and build solar street lights, so let's talk about solar LED street lamp installation and construction scheme. Composition and working principle of solar street lamps mainly by the solar street lamps, intelligent controller, battery, solar panel component of light source, light pole and bracket. Solar street lamps using solar panels convert solar radiation into electricity during the day, and then through intelligent controller to electrical energy stored in the battery. When night came, the sun's light intensity gradually weakened. When intelligent controller detected intensity drops to a certain value, it controls the battery supply power to light load in this way, dark, light will open automatically. Intelligent controller to protect the storage battery charging and discharging, and open and the light of the light source control time. A base casting 1. Determine the installation position of street lamp: according to the construction drawings and the geological conditions of the field, on the top of the lamp shade place, with 40 meters determine the installation position of street lamp, street lamp spacing for a reference or the lights should be appropriate to replace the installation location. 2. Street lamp excavation: street light foundation pit excavation shall be installed in the street lamp fixed position. If the soft surface, the excavation depth will deepen. And confirm and protect other facilities ( Such as cables and pipelines, etc. ) In the excavation site. 3. To build a battery pack in excavation of the foundation pit, the battery. If the excavation is not wide, excavation will continue to be wide enough to accommodate air between the battery pack. 4. Street lamp based embedded parts casting: in 1 m deep excavation pit, will advance the welded embedded inserts into the pit, and put one end of the steel tube in the middle of the embedded parts, on the other side in a battery buried place. And keep the embedded parts and foundation and the ground at the same horizontal plane. Then use C20 concrete pouring and fixed embedded parts. Pouring process, stir well, keep the compactness and strong degree of embedded parts. 5. After completion of construction, timely cleaning residue on the positioning plate. The installation of solar street light only in concrete after complete solidification ( About 4 days, 3 days), if the weather is fine 。 The installation of solar street light component 1. Install solar panels 1. Put the solar panels on the bracket of panel, with screw, make it strong and reliable. 2. Connect the output of the solar panel line, pay attention to the correct connection panels are negative, and tie the output line of fixed panels. 3. Connection wire connection, the panel should be tin plating, to prevent the oxidation of the wire. Then the panels on the side of the connection, waiting for the thread. 2. Install the led lamp 1. Line wear out from the arms, the lamp in the socket set aside a light at the end of the line used to install the lamp holder. 2. Support beam of light, will the other end of the lamp line from a lamppost reserved thread through the hole, and one end of the line to light the lamp plug. The other end of the filament equipped with lamp holder. 3. Aligned with the screw hole lamppost lamp arm, and then use quick wrench and tighten the lamp arm. Visual observation lamp arm not skewed, tighten the lamp arm. 4. One end of the tag line across the top of the light pole lamp, with a fine thread tube will be two wires and solar panels one end of the line together to wear to the bottom of the light pole, and fix the solar panels on a streetlight. Check all the screws are tight, after waiting for the crane.