Monitoring stent coating process and welding process, the quality of the sun

Monitor stent coating process and the quality of the welding technology of 2020 - 09 - 21 hits: 235 in monitoring of production process, to ensure that monitoring stent coating process and the quality of the welding process, welding should be adopted in the process of welding, so as to make the whole monitoring



monitor stent coating process and the quality of the welding process

- 2020 09 - 21 hits: 235

in monitoring of production process, to ensure that monitoring stent coating process and the quality of the welding process, welding should be adopted in the process of welding, so as to make the whole monitoring support whole without welding, welding rod body and no defects. Plastic spraying process to adopt some imported high quality plastic powder, it can ensure that monitoring stent surface rust. After the coating needs to be done in certain passivation, so the performance of the monitoring support will be more stable. Outstanding performance in the development of modern electrical engineering field is limited to the development of the wireless, followed a group of high and new technology into our life, we can completely fantasy in the future we are not in order to pull line, check the line son chagrin, monitoring pole manufacturers think that our products are suitable for the development of wireless trends, timid to finish up more simple and practical. Said that the main reason is the solar energy technology development and improvement of monitoring pole can fully match solar battery and converter, monitoring pole huge capacity perfectly acceptable to hit the component of harmonic components, and monitor the application of rod places also tend to be perhaps the wild road on both sides, the solar energy use efficiency is extremely high, under normal circumstances, the solar energy resources can be fully satisfied power monitoring bar equipment. Carry solar equipment monitoring pole strengths, there are many, one of main strengths is the criminal in damage is not so simple, monitoring pole equipment as long as it is now put a broken line, of the journey to monitor stem was completely lost and then became a decoration, but with a solar energy equipment monitoring stem would not be so, a damaged, the other can be normal use. So, monitoring pole factory, monitoring is carried out in solar energy bar. When used outdoors monitor bracket, need to make full investigation and analysis of the terrain, needs to be embedded in advance under certain reinforced ground, with extremely high by the wind, and in accord with GBJ204 - and ratio of cement for 83 regulations, to ensure the stability of equipment operation, and improve the strength of monitoring, effectively improve the city's traffic convenience. Monitoring pole in the process of installation, in different bolt should formulate the relevant security equipment, according to the address of the embedded and installation drawings, to correct the implementation of the control rod embedded, help to improve the smoothness of roads, will not affect traffic or inconvenience. Secondly, will monitor to waterproof measures, avoid the rain for a long time and cause equipment appear water phenomenon.