Light, structure principle and installation of the note

High lamp is usually composed of two or three pole, to pay special attention when installation, every two plug, each splice depth shall not be less than 60 cm, if the plug does not reach the designated position, don't worry it will fall down, but will affect the light, the overall

high lamp usually consists of two or three sections of steel pipe. The installation process should pay special attention to. When two mutual insert, insert depth shall not be less than 60 cm. If you insert does not reach the designated position, do not have to worry about it will fall down. However, this will affect the overall vertical degree of light, led to the weaving. If you insert in place, there would be no problem. High lamp at the top of the top, the fixed position of the hook, all connected by three M14 or M16 screws. Should be paid attention to during the installation process, the three screws must be stainless steel screws. Many high lamp manufacturers ignored the problem, use common galvanized screws. After such a long time, the iron screw will serious rust, caused by decoupling is difficult, or cannot be decoupled. Light appear problem, after the lamp panel to raise. Shandong solar technology development co. , LTD. Is located in; Home of China street light; Shandong, shandong. Company set design, research and development, production, sales and after-sales service as a whole, is a road lighting and system solutions provider.