Light, solar street lamps which good foundation construction steps how to do

High lamp is made of high quality Q235 material, this material use time for a long time, and easy to manipulate. Moreover in fastening nut, must add gasket, or a trampoline. The distance after fastening screws exposed nut shall not be less than two pitch. In growing



high lamp' Light, generally refers to more than 15 meters steel conical light pole and high-power modular fixtures are composed of new type of lighting. 】 USES the high quality of Q235 material, this material use time for a long time, and easy to manipulate. Moreover in fastening nut, must add gasket, or a trampoline. The distance after fastening screws exposed nut shall not be less than two pitch. At the top of the light, the position of the set lightning rod 【 Lightning, and lightning protection needle, is used to protect buildings, tall trees, etc to avoid lightning device. 】 , and the lightning rod to independent setting and long needle is half a metre commonly. Around the base of lamps and lanterns to a multitude of grounding body, in the face of grounding resistance, earth accepted length has specific requirements, such as, so in fabrication and installation must be in accordance with the relevant requirements for the construction. Have light pole grounding body, lamp and distribution box and so on carries on the reliable connection, finally forms the reliable conductive pathways.

- 1 - To light pole, stronger wind resistance, foundation pit to dig side length 3 meters X3 meters, 3 a 3. 5 meters, in the cross on the cage. Longitudinal strap on a few root reinforcement, the appropriate threading pipe fixed well, in case of power supply of lamps and lanterns.

- 2 - Around the embedded parts fixed with wood and wood into a 2 meter X2 meters square, and the pit left around 5 o cm thin between street lamp lighting manufacturers, in case with plaster mixed with loess filling after basics, cement, to prevent water flowing down around, cause the tilt of lamps and lanterns.

- 3 - Long arm lamp embrace hoop must wear double box, with pole fixation, declined. The various parts of the lamp body should be straight, tighten the screws, feeder and the lamp body is not less than 330 ° Angle, light body and the road, vertical long arm lamp lamp body is installed, the front-end should be about 100 M/M to a flexible.

- 4 - Cement floor part of the new maintenance must pass a certain maintenance rear can construction, about 28 days. Effectively remove oil on the surface, the king cleaner in grams of oil processing, factory water inside the room, and make effective drying damp place.

- 5 - Epoxy paint in features: has good adhesion, high hardness, good mechanical strength, good abrasion resistance, impact resistance, with the contact of the primers and paint, focus on good, at the same time in the construction of the middle to leveling the ground substrate, make the floor surface of paint for better visual effect.

- 6 - Available exclusively use thinner coordination face paint viscosity, generally in 0 ~ 10%, the amount can't add too much thinner, otherwise affect the hiding power and gloss.

- 7 - When the coating construction has been completed, do not use during the maintenance period, and must strengthen the ventilation and fire prevention measures. The use of the ground floor, production personnel are not allowed to wear with nails shoes to walk on it. With acute Angle of the metal parts are strictly prohibited items such as collision, ground floor coating caused by damage to the ground.