Installation and wiring led solar street light, solar led shenzhen note

LED street light wiring method puts lamps light pole, would be enough length of red and black wire wear into the lamp post, until in the bottom of the light pole, adjust Angle, use screws to fix it. The brown line power input cable and power supply side phase line ( Red) Connection, electric

a led street lamp wiring method

put the lamp on the light pole, on the light pole inserted enough red and black wires, until the lights on the bottom of the light pole, adjust the Angle, and screws. The brown line power input cable and power supply side phase line ( Red) Connection, power input cable blue line to power the zero line ( Black) Connection, power input cable yellow line and grounding protection line ( Anchor bolt) The connection. After connection strong right, joint should be insulated waterproof. After all the installation is complete, check the electric door unlocked, turned on the power, the lamp can work.

install solar street light note

a, lamps and lanterns, installation and wiring must be conducted in the case of power failure.

the power cord connector must be insulated and waterproof.

c cover open, power supply shall not electricity, in order to prevent electric shock.

d, lamps and lanterns of the glue shall not be arbitrarily cut, to prevent the influence of insulation and heat dissipation.

capacity calculation of solar panels;

for solar street lamps, the overall system configuration formula is: P = light power x light working hours/peak sunshine time; The p is the power of the battery pack unit is w; Light work unit of time for hours, peak sunshine time unit for hours.