Install solar street lamps in the street lamp should pay attention to the problem?

Residents from large solar photovoltaic power station to user photovoltaic system, from the photovoltaic building integrated ( BIPV） To solar lights for all levels of the urban and rural areas, providing professional and credible solar application products. Efforts to provide customers with high quality solar



from large solar photovoltaic power station 【 Solar photovoltaic power station by the solar cell phalanx called solar radiant energy into electrical energy power station solar photovoltaic power station. 】 To residential users photovoltaic systems, photovoltaic building integrated 【 Solar building integration ( 即BIPV建筑一体化光伏、PV即光伏) Is a solar power generation ( Photovoltaic (pv)) Products are integrated into the construction technology. 】 （ BIPV【 BIPV is Building Integrated photovoltaic PV is Building integration. 】 ） For all levels of the urban and rural areas of solar lamp' Solar energy lamp is by solar panels light into electrical energy. 】 , providing professional and credible solar application products. Efforts to provide customers high quality solar system solution, solar street lamps system 【 Solar street lamps system consists of eight elements. 】 Design and installation services, with leading photovoltaic (pv) grid technology and the most photovoltaic building integrated of safety requirements and aesthetic art of the building ( BIPV） The solution. A, solar street lamp installation time. Should be installed in sunny day, if installed in rainy day, after the lights charging power consumption not only, can not meet the design requirements; Second, solar street lamp installed lights should not be on the same day. Many engineering contractor in order to rush to see

light effect, installed the evening lights. Because the new battery in the delivery time is not full of electricity, if installed lights, is the number of rainy days can not meet the design. Is the right thing, after the installation, then good

controller, but don't pick up the load, the second day Bai Tianchong after one day, the evening to pick up the load, thus the capacity of the battery can achieve a higher degree. Of course, part of doing so would increase labor cost. The point of view of three panels, solar street lamp, general factory is designed according to the 45 degree Angle, this is to ensure that the winter can have a good charge. But direction Angle is determined by the installation time, in the underground assembly too

board, found that the light pole after the set up Angle deviation, if partial, generally will not adjust. The angular deviation in addition to affect the charging thought, will also affect the voltage of solar panels under the same light, will guide the

to solar street lamp lights time error is larger. Therefore, when assembled on the ground, try to adjust the Angle of solar panels and keep consistent! Four, solar street light controller connection. Should try to use waterproof controller to ensure long-term stability at the same time, also can avoid the user change lights on time. Such as using the controller is not waterproof, due to the terminal blocks down, wiring a u-shaped bend, this can prevent water from online pour into the controller. Five, should try to persuade customers to use good quality copper core. Due to the conductivity 【 Conductivity, physics concepts, can also be referred to as the conductivity. 】 The cause of the current and voltage in the process of the output will be a certain loss, this not only increase the power consumption, severe cases can lead to

the LED driver power supply cannot work normally. I have been in a construction site and found a problem, the parameters of the drive power set up correctly, in the laboratory using everything is normal, but after loaded on the lamp holder, the light is 15 seconds out. The

check, line because of poor quality, the loss is bigger, since the controller output voltage to the lamp holder, already cannot satisfy the requirement of the drive power supply parameters. Such as encountered such a problem, can be scored on the driving power supply from the lamp holder,

installed in the bottom of the light pole, it can solve the problem. But will lose some photosynthetic efficiency. So, it is important to choose a good conductor, or do more harm than good.