loading

We are a leading manufacturer of solar power utilization and lighting systems                   Mob:+86 199 2801 5868

Incorrect erection general solar street lamps garden light solution

Wrong installation of solar street lamps solution with new rural support full, more and more solar energy street lamp to replace the traditional grid lamp. It used to be a reasonably good, but because in actual installation did not please the professional construction of



mistake to install solar street lamps solution

as the new rural support full on, more and more solar energy street lamp to replace the traditional grid lamp. It used to be a reasonably good, but because in the actual installation without professional construction personnel for installation, many customers still following the traditional way to install solar street light, caused the lamp holder not shine after installation, or evening light soon not shortcomings. Installation problems, will naturally to the normal street light can't shine, cape below lighting electric co. , LTD. Is a master rural several wrong installation of solar street lamps are summarized and its solution. 1, solar panels towards mistakes need to install photovoltaic panels before stem secured the photovoltaic panels shall, if discovered after stem photovoltaic panels towards rendering errors, will result in photovoltaic panels can't fully absorb sunlight to charge. Solution: first to determine the underlying purpose of the LED light, and then determine the towards of photovoltaic panels, install photovoltaic panels should be toward the sun is the most abundant the underlying purpose of installation, facing should be toward the south, the installation Angle differences also has effect on the output of photovoltaic modules, do solar stent to look at the latitude of installation address 2, not correctly use the remote controller, some construction personnel will not correctly use the remote controller, random and ensure that is no matter with the lights burning. In fact this length often wrong operation, at the same time of random may have set the wrong parameters, result in abnormal lights, lighting time is too long or light time is too short solution: formal manufacturers usually have professional installation personnel on-site guidance, debugging good all parameters of the solar street light. 3, installation place mask too much the solar street light is through the top of the solar photovoltaic panels absorb sunlight, then converted into electrical energy stored in the storage battery, night again through the battery discharge to power leds for lighting. So night can normal lighting, solar street lamps depends on solar photovoltaic panels can receive the sunlight in the day, if too many obstructions around the solar street lamps, such as: the leaves can cause shade, building and so on, affect the normal absorption of the solar surface light source and operation, resulting in a decline in charging efficiency. Solution: when installing solar street lamps should be far away from obstructions, if can't steer clear of obstructions, to ensure that the solar photovoltaic panels of the south mark purpose no obstructions, or light time not less than 6 hours. 4, next to have other solar street lamps light source relative or intelligent street lamp, solar street lamps it can operate electric to the differences of the four seasons dark time to adjust, don't need to reward. If there are other light around the photovoltaic panels, leads to a light-activated spirit, solar street lamp light in nature cannot be normal. When installing a solar street lamp, stay away from other light sources, to avoid interference. Solution: if the solar street light has been installed, found its photovoltaic panels with light source and can't remove, should be adjusted in time control mode.

GET IN TOUCH WITH Us
recommended articles
Knowledge News & events Project
ALLTOP Cordially Invites You | Join Us at WETEX 2026 Dubai Solar PV Exhibition to Explore New Opportunities in the Middle East PV & Energy Storage Market!


Exhibition Name: WETEX 2026
Exhibition Dates: October 20–22, 2026
Venue: Dubai World Trade Centre · Dubai, UAE
ALLTOP Booth: 4C14
Warm Invitation | ALLTOP Debuts at the 140th Canton Fair, Jointly Witnessing a New Future of Green Energy

Exhibition Name: The 140th Canton Fair)
Exhibition Dates: October 15–19, 2026
Venue: China Import and Export Fair Complex, Guangzhou, China
ALLTOP Booth: Zone C · Hall 16.4 · Booths C34-C35, D08-D09
Golden Topping-Out Marks a New Milestone, Output Value Exceeds RMB 600 Million! ALLTOP Industrial Park’s 168,800 m² Project Successfully Topped Out

318 Days—Less Than a Year!

At the “Speed of Light,” from Blueprint to Topping-Out.

50.24 mu of Prime Land, 168,366 Square Meters of Intelligent Manufacturing Space,

Annual Output Value at Full Production Exceeding RMB 600 Million.

ALLTOP Speed, Formidable Strength, and a Promising Future!

Golden Topping-Out Shines, Output Value Soars
The Hype Is On! ALLTOP Draws Global Spotlight at the Solar Expo — Join Us for a Chat
SOLAR PV & ENERGY STORAGE WORLD EXPO 2026

Booth No.: 10.2· B551
Time: September 16–18
Address: China Import and Export Fair Complex, Guangzhou, China (No. 382 Yuejiang Middle Road, Haizhu District, Guangzhou)
ALLTOP UGANDA Invites You to Power and Elec Expo 2026

Exhibition Name: Power and Elec Expo 2026

Date: July 9th-11th 2026

Company Name: Alltop Engineering Uganda

Hall No.

Booth No. A45

Venue: UMA Show grounds, Multi-Purpose Hall, Kampala-Uganda
Our aim is to provide the best products and the most considerate service for customers.
About Us
Customer service