How to install solar street light?

Lamp now relevant to our daily life, to the metropolis, down to the countryside, street light got popular, but the dosage of street lamps, more demand for electricity, so can not develop new solar street light. Solar street lamps placed: 1) 。 Light pole,

street lamp now is closely related to our daily life. Street lamps are widely used in the big cities and villages. However, due to the use of street lights and more demand for electricity, new solar street light can't development.

the installation of solar street light: 1) 。 After installing light pole, began to look at all of the components ( Solar panels, battery, light source) The wire is connected to the controller. ( Please refer to the specific controller wiring diagram) 2) 。 First of all, will be directly connected to the battery light source wires, check that the light is on. Then, the light source can be determined is the cathode wires ( Light is negative reverse connection, light is not bright, so light won't damage, lamp can be safely test) 。 Then, connect the positive wire of the light source to the controller corresponding to the light bulb icon on the red line of anode line and light source is connected to the controller corresponding to the light bulb icon on the black line. 3) Multimeter is file to check the battery socket is negative, the DC voltage to the battery positive electrode wire is connected to the controller on the battery icon corresponds to the red line, connect the battery negative line controller battery corresponds to the black line. 4) Multimeter is a DC voltage archives check solar panels across the electrodes of lead, will the positive line connected to the controller of the solar panels on the corresponding solar panels icon on the red line of the solar panels of the cathode lines connected to the controller corresponding solar panels on the black line. 5) 。 Controller has been debugging in the factory, intelligent lighting time has been adjusted. After the connection is not need to debug controller, controller will take the initiative to enter the state. 6) 。 Too thin: when placed the battery box, tighten the screws and waterproof threading pipe. Into the lamp base, waterproof threading pipe should be higher than 20 centimeters of above ground, to ensure that the lamp when the rain flooded the flange will not into the battery compartment. In addition, should be limited and select place, in order to avoid stagnation objects blocking solar panels, to prevent solar panels can't charge like a war.