How to calculate the lift thickness of light weight price

Lift the weight of the light is determined by the thickness and diameter, a lot of clients in customized lift when high lamp will habitually ask high lamp manufacturer for wall thickness problem, because the customer understanding, wall thick degree determines the lifting of the lifespan of the light, and corrosion resistance, so it is particularly important.

many lift high lamp manufacturers will not care about customer questions, because they can be as much as possible into the thick of the said, such as 6 mm thick they submitted to 8 mm, 8 mm thick they say 10 mm, etc. , in a word & other; Buy than sell fine & throughout; 。 Manufacturers don't do not afraid from being discovered by the customer? You also don't say that they are not afraid, why do you say so, because they have plenty of ways to cover up & other; The truth & throughout; 。

first lift bottom flange part of the light, the next you can't measure, is because the flange and the tube cross section welded together, as long as good welding after who all can't measure. Then there is the link at the top of the circle, this part cannot measure, because the top have a triangular piece of lightning rod fixed plate is covered the diameter full welding on the whole, therefore, there is no way to measure.

XinPeng flying lift high lamp

see that some friends will say, that's always can measure the splice in the middle of the paragraph? Yes, there really can be measured, but factory still have the means to deceive pass a barrier, the lifting of light, first of all, the anti-corrosion technology is hot dip galvanized coating, the thickness of the galvanizing for 85 & mu; M, the thickness of the plastic spraying is 0. 3 mm, the thickness of the two kinds of process together is close to zero. 5 mm. Finally, there is a recruit more perfect & ndash; Thickening of tapping method, the fresh word, maybe a lot of friends don't understand, but what I said you understand, the so-called thickening of tapping method, refers to by the hammer knock around the rod body diameter and steel pipe wall stress will head to the side after the expansion, the result is obvious, isn't it? Wall thickness increased 1 - 2 mm is so simple.

identify lift high lamp wall thickness have moisture is not no way, we can through calculating way to measure the weight of the rod body wall thickness accuracy, such as relatively simple calculation formula ( Fluently under + & times; High & divide; 2× 3. 14× Wall thickness & times; Density = weight) To do a simple calculation, and then the weight bridge over it, if the component is not on, that must be false.

and a method is simple, it is touched, a finger to touch the sides of the inner diameter, diameter if is struck, there will not be smooth, then just use grinding flat steel file, and then measured with a caliper, this is the most accurate measurement results of the actual wall thickness.