Home solar panels should be in solar photovoltaic power generation systems

Home solar panels is the center of local solar photovoltaic power generation system, solar panels is the role of the sun's light energy into electrical energy, the output direct current in the battery. Solar panels is an important department in household solar power

home solar panels is the core part of solar photovoltaic power generation systems. Solar panels function is to convert solar energy into electrical energy, then the output direct current (dc) stored in the battery. Solar panels is one of the most important parts of household solar power generation. The conversion rate and service life is an important factor to decide whether it use solar cells. How about home solar panels 1. Cell: adopting the high efficiency ( 16. More than 5%) Monocrystalline silicon solar encapsulation, ensure the solar panels have enough capacity. 2. The thickness of the glass: 3. 2 mm low iron tempered suede glass ( Also known as the white glass) In the solar spectral response wavelength range ( 320 - 1100 nm) Light transmittance is greater than 91%, to more than 1200 nm infrared light with high reflectivity. Glass can resist the sun's ultraviolet radiation at the same time, the light transmittance is not falling. 3. EVA: high quality EVA film layer, thickness of 0. 78 mm, adding anti-uv agents, antioxidants and curing agent, as sealant of solar cells and connection with glass and thermoplastic polyurethane. It has high light transmittance and anti-aging ability. 4. TPT: as fluorine plastic thin film solar battery back cover is white, can reflect sunlight and thus slightly improve the efficiency of the module. Due to its high infrared emissivity, it can also reduce the working temperature of the module, and also is helpful to improve the efficiency of the module. First of all, of course, this kind of fluorine plastic film is solar battery encapsulation materials required by the ageing resistance, corrosion resistance, airtight etc. Basic requirements. 5. Frame: used for aluminum alloy frame with high intensity, mechanical shock resistance ability. It was a high value part of the household solar power generation. Its function is to convert solar radiation into electricity, or store it into the battery, or promote work load. Using solar panels to note: 1, check whether the panel is damaged, to be found in time, change in time. 2, check the panel wire and ground wire can contact is good, if there is a phenomenon of scattered. 3. Check the connection of the junction box for fever phenomenon. 4, check whether there is any loosening and fracture on panels stents. 5. Check and remove panels around the block panels of weeds. 6. Check the surface of the panels for mulch. 7. Check the bird droppings on the surface of the panels, if necessary, to stop cleaning. 8. Stop the purity of the review panel. 9. In the windy weather, panels and support should be focusing on stop. 10. In case of heavy snow, immediately stop clear panels, to prevent the occurrence of snow and ice surface of the panels. 11, should check whether all waterproof seal when the rain is good, if there is leakage phenomenon. 12. Check whether animals can enter the station stop destroying panels. 13, the hail weather should stop focusing on the appearance of the panels. 14. Stop the temperature of the test panels, and then compare it with environmental temperature.