High lamp operating procedures

Light is one of the main product of high lamp factory, then, we strongly recommend the following introduction for you, perhaps you can benefit a lot. Below small make up for all to the light, the operation procedures.

on the lifting operation, high lamp facilities non-work personnel and lifting operation staff must stay away from more than 10 m high lamp light pole center, an operator shall not be used at the same time the manual and electric operation, should establish safety fence surrounding the safety area, field workers should wear safety helmet, irrelevant personnel are strictly forbidden to stay at the scene. Should check transmission oil before lifting operation whether fill, electrical parts, transmission device and the braking device is safe and reliable, and the trial operation manual crank, and in the absence of exceptional circumstances to open the power switch for lifting operation. In high lamp lifting process should pay attention to the gearbox with or without abnormal noise, noise is necessary to stop the machine immediately to check, if any, until the troubleshooting rear can continue lifting operation. Light, the light to the top of the plate to automatically hook so that wire rope and gearbox unloading is finished. Lamp panel fall first from unloading operation, to operate, lamp panel down until the manufacturer specified distance from the earth. Maintenance personnel climb lamp plate should fasten your seat belt, when lamp on the tray can be at most two maintenance staff.