High lamp installation steps

In general, light, its frame structure as the main functional matters, also is give priority to with decorative materials, and then to steel and steel pipe, high lamp light pole and used in the lamp panel used are hot-dip zinc treatment. Its electric hoist speed is by electric

in general, light, its frame structure as the main functional matters, also is give priority to with decorative materials, and then to steel and steel pipe, high lamp light pole and used in the lamp panel adopt are hot-dip zinc treatment. It is by an electric motor, electric hoist speed of windlass, three sets of hot dip galvanized empty root of wire and cable, and so on, the following is a brief introduction of its installation steps.

1, before installing the deft, must according to the loading and packing list carefully check all the components, to avoid missing some small parts, lead to can't install high lamp, or because of the lack of a fine speak ah, installed after the light, brought a lot of hard to avoid the danger.

2, to check all the components to see if there is any breakage, bending, or a state of distortion, and check whether the galvanized layer do damage.

3, light, each section of the panels are marked on the body of the rod body type, order number and block number, in the rod body side with marker indicating the how much is the weight of the rod body, before the lifting, must see if crane to hoist rod body, see if capacity is enough.

4, installation of the master must according to the drawing provided by the maximum and minimum of the socket length, and then on the rod body marking, using common socket. When install also must be careful, don't put the socket of the, the way that is easy to cause high lamp stand, of course, master in the installation, also must pay attention to their personal safety.

every joining together to provide a set of joint length, but because of the manufacture and installation error, or is the effect of physical factors and so on, the change of the socket length, so provide the minimum and maximum lengths of the socket socket length.