High lamp installation of the fence gate brick pillars process design is divided into a few

With the improvement of economic level, people demand for road lighting at night also subsequently heighten. And high lamp as a large lighting appliances, because of the irradiation range is wide, brightness is good, widely used in outdoor lighting of the project, many areas are now installed high



with the improvement of economic level, people has increased to the requirement of road lighting at night. The light' Light, generally refers to more than 15 meters steel conical light pole and high-power modular fixtures are composed of new type of lighting. 】 As a kind of large lighting appliances, because of the irradiation range is wide, brightness is good, widely used in outdoor lighting of the project, now a lot of areas are set up to the light. But high lamp actual installation has a lot of people have a headache, and often don't know how to properly installed, under the sea ray lighting today is to introduce what is light, the correct installation process.

- 1 - The preparation before installation

1. Pay attention to in the process of installation transportation shock

2. High lamp pay attention to shut off the power before installation to avoid improper operation happen to get an electric shock the

3. Power lamp body wire damage is found, immediately stop using the

4. Will be marked on inspection project-light lamp voltage are consistent with the input voltage,

rural solar street lamps

- 2 - Installation instructions

1. Will dock high lamp signal wire and three core controller, connect the power cord and switch power supply 2 core without thread wrapped in waterproof tape,

2. According to the power transformer and project-light lamp power calculation for each transformer can hold how many project-light lamp

3. Transformer on goods received 220 v mains switch power supply, using air switch, time switch control unified electricity, main controller plug on 220 v power supply.

4. High lamp first controller, lamps and lanterns signal to control signal, each controller can only take the fixed quantity of led light.

- 3 - Installation test: led light source such as a virtual welding welding leakage, waterproof processing not inferior product such as back light manufacturer, due to the high lamp installed in the outdoor environment for street lamp life influence is very big, need to product high temperature resistance, heat performance, suggest early specified brand on the product selection, save maintenance cost; Try to cast light can't normal quantity in light electric appliance part first, no problem to change controller, communication with manufacturer for technical problems, to solve the problem.

that is light, the correct installation process, whether prior to or after installation, the installation we all need to pay attention to some matters, in accordance with the procedures and requirements for high lamp installation process correctly.