Garden lamp manufacturer about garden lamp basic component package

Garden light sheath line, blue line core said anode, red wire core is positive. Rule applies to solar street light attachment. With a width of 60 cm of the gas film mat light pole components, gas film mat part for its pressure to one 6 of the width ( The 10 cm) , gas film mat

 courtyard lights sheath line, blue line core said anode, red wire core is positive. Rule applies to solar street light attachment. With a width of 60 cm of the gas film mat light pole components, gas film mat part for its pressure to one 6 of the width ( The 10 cm) , gas film mat need a distance joint tape wrapping 3 laps, and then the rope winding, spacing for 100 + 10 mm. Lampposts component sheathed wire from the lower pole of the strip length is about 200 mm leather sheath, garden lamp and then in solar cell' Solar cells can effectively absorb solar energy and convert it into a power semiconductor components. 】 Component sheathed on both ends of the line to do the 'solar battery components' logo, at the same time must ensure that the logo is clear, not easy to fall off. Courtyard lights will have prepared the solar cell components ( Solar energy battery components is of high efficiency crystalline silicon solar cell lines of toughened glass, super white cloth, EVA, transparent TPT backboard and the composition of aluminum alloy frame. 】 Line connect battery components end by stripping pliers 【 Wire stripping pliers is inside the electrician, electrical motor repair, instruments and meters commonly used one of the tools, used for electrical strip wire head surface insulation layer. 】 Skinning open 30 mm line, to expand the wire line core through the wire core tight after returning, then with insulating tape 【 Insulating tape is an electrician class supplies, also called electrical tape, used to bind up the thrum of the bare or metal insulation effect, avoid accidental electric shock or short circuit. 】 And fine wire line core fixed firmly, twitched on the wire component at the top of the light pole line out of the allowance and set aside 500 mm to 1000 mm, will be on the bottom of the light pole end components of coil good cable ties with 200 mm after 【 Cable ties, nylon material of a kind of cable tie. 】 Tighten and into the lampposts, on the top of the light pole on the light pole with the components of the line. Solar cell components sheath line for two commonly, so wear a wire in advance should wear two wire, when wearing them one by one in sheath line. Garden light every wear after the solar battery components sheath thread, immediately to do identified and fixed upper sheathed on both ends of the line.