Full solar street lamps

Solar energy lamp lamps and lanterns should first when installed on each part component is fixed: solar panels fixed on the bracket of solar panels, lamp holder fixed to carry on the arm, then stent with arm fixed to the main stem, and wear the cables to control box ( Battery box) 。 Light pole up

to install solar energy lamp lights, must first be fixed parts: the parts of the solar panels on the solar panel bracket, lamp holder on the pick arm, then stent and pick arm fixed on the main stem, connecting to control box ( A battery pack) 。 Lamp before ascension, check whether the parts fasteners, lamp holder installed correctly, the light source is working correctly. Then, simple debugging system is working correctly; Loosen the controller of solar panels on the cable, light work; Connect the solar panels cable and turn off the lights. At the same time, carefully observe the controller light changes. Only when everything is all right, it can be filed and installation. When lifting the main light pole, pay attention to safety matters needing attention; Fully tighten the screw. If the component in the deviation Angle of sunrise, it is necessary to adjust its facing south direction of sunrise. Put battery into the battery box, according to the technical requirements will be connected to the controller. First connect the battery, and then connect the load, and then connect the solar panels. During the connection operation, must pay attention to the controller of all wiring and terminals can't tag on wrong connection, positive and negative polarity not conflict or reverse connection. Otherwise, the controller will be damaged. Debug the system is working correctly; Loosen the controller of solar panels on the wire, the light will light up. Connect the solar panels cable and turn off the lights. At the same time, carefully observe the controller light changes. Only when everything is normal, the control box can be sealed. In addition, on the ground when installing the lamps and lanterns of high lamp, should pay special attention to the installation position of solar panels, and shall ensure enough sunlight photovoltaic battery module, lest affect the lighting effect of lamps and lanterns. Therefore, when choosing installation position, the solar cell module can light falling at any given time period, and there are no obstacles such as the leaves. The thread, make sure not to clamp lamp connection wires. Wires should be solid and PVC tape. In order to ensure the appearance is beautiful and the battery pack better receiving solar radiation, had better clean once every six months the dust on the battery pack, but don't rinse area from the bottom up. YWX promotion best quickly push children]