From a performance point of view, the pros and cons between induction lamps and LED lamps

From a performance point of view, the advantages and disadvantages between the induction lamp and the LED lamp. Technical advancement. Research and development began in 2010 and sales in 2016. In the most advanced stage of light source development, standardized products fully meet the needs of the market, so this high-tech product is suitable for large-scale production. The first red light LED was successfully developed in 2009, and it has been developed in recent years. However, it was not until 1970 that the first white LED was successfully developed. Because of frequent replacement and high investment risk, especially in situations where functional lighting cannot be applied, its overall development speed appears to be slow. LED uses semiconductor technology, and the energy consumption in the production process is extremely high. Applications Industry, commerce, roads, tunnels, bridges, gardens, agriculture, advertising and other lighting fields, with a wide range. Special lighting fields such as traffic signals, car taillights, mobile phone screen backgrounds, display screens, decorative lighting, etc. cannot be applied to the functional lighting field with the largest market capacity like low frequency. Technical indicators • Power: W~W•Light efficiency: > lm/W•Color rendering:> Ra•Color temperature: K~K full range•Light decay: %@ hours•Life time: ≥, hours•Caloricity: It is a cold light source with very low calorific value•Lamp supporting: easy Matching•Surface light source: no glare, no flicker, superior visual effect. •Each grain is: .~W, high-power applications need hundreds of grains together to achieve. • Luminous efficiency: Ra • Color temperature: narrow selection range (white light LED) • Luminous decay: >%@ hours • Service life: <, hours • Calorific value: very High, so a heat sink is required. • Lighting accessories: As hundreds of LEDs are concentrated on a large circuit board, it is very difficult to design the lamp reflector, and it is very difficult to promote and apply. • Point light source: with dazzling glare and flicker, serious light pollution. Comparison items Induction lamp LED diode light source technology name and characteristics Low voltage electromagnetic induction light-emitting surface light source, suitable for high-power functional lighting Solid state light-emitting diode point light source, suitable for display lighting market capacity, induction lamp as an advanced functional lighting source, can replace all Traditional functional lighting source. The market capacity is immeasurable. Although LED has been developed for decades, it can only be used for display lighting, traffic signal lights, car taillights, highway guidance lighting or decorative lighting due to its low light efficiency, low power, and lack of supporting lamps. Economical The cost of induction lamps will be the same as or even lower than traditional light sources with mass production, thus creating conditions for popularization and application. The cost is high, it is difficult to adapt to the wide-ranging needs of the market, and the market promotion and application efforts are limited. Energy-saving rate Infinite lighting efficiency is higher than that of LED by more than%, and the light attenuation is less than that of LED, so the energy-saving rate is about% higher than that of LED. LEDs have low luminous efficiency, low power, large luminous decay, and high heat generation, resulting in lower energy-saving effects than low frequency.