Don't let the construction affects the use of light

Before and everyone to share in light, common construction quality problems in fault, in the light of construction is too long will have what problem is resulted in high lamp doesn't work? Look at together: 1, the shop is cable dragging on the ground;

before and everyone to share in light, common construction quality problems in fault, in the light of construction is too long will have what problem is resulted in high lamp doesn't work? Look at together: 1, the shop is cable dragging on the ground; 2, high lamp corridor pipe production and installation does not conform to the requirements, both ends not made syndromes according to the standard beep mouth; 3, in cable trench depth is not enough, sand brick not according to standard construction; 4, line nose and the thickness of the insulation wrapped pressure is not enough, after a long run short circuit will alternate with, these are some of the common problems in the construction; 5, light, the basis of embedded pipe is not in accordance with the requirements of standard construction, is mainly embedded pipe carefully, coupled with a certain amount, LED street light, wear when cable is very difficult, in the base at the bottom of the 'dead turn'. These factors can result in high lamp can't normal work for everyone, so, in the light of the construction process must pay attention to is that the number of some matters needing attention, avoid light, cannot be used again by the phenomenon to appear! Small make up: Ann