Courtyard lamp manufacturer which good?
Garden light is the park, an important part of the scenic area, the park lighting, whether led garden light, solar garden light, the scope of application is very extensive, it highly in 3 - in general 5 meters, aesthetically pleasing, satisfy the need of daily road lighting, and compared with the solar
garden light is the park, an important part of the scenic area, garden lighting, whether led garden light, solar garden light, the scope of application is very extensive, it highly in 3 - in general 5 meters, aesthetically pleasing, satisfy the need of daily road lighting, and compared with the solar street lamp, garden lamp price is cheaper, so the manufacturer of garden light is also very much and very popular.
and solar street lamps garden light manufacturers, basically do courtyard lamp, street lamp manufacturers can be easier and garden light, from the cost of steel, is also less. But not all of the garden light price is lower than the solar street light, still should see the modelling, if it is a very complicated shape, the price is hard to say.
garden lights and solar street lamp installation method about the same, basic process and procedure is the same:
1, for each part component is fixed: solar panels fixed on the bracket of solar panels, lamp holder to carry on the arm, then stent with arm fixed to the main stem, and wear the cables to control box ( Battery box) 。
2, light pole before operation, each part of the first check fasteners, lamp holder to install whether correct, light work is normal. Then work in simple debugging system is normal; Loosen the solar panels on the controller cable, light work.
3, the main light pole lifting, pay attention to safety; Screw fastening absolutely good, sunrise Angle deviation, such as the component needs to adjust the direction of the sun completely up to end toward the south.
4, put the battery into the battery box, according to the technical requirements will be connected to the controller; Connect the battery, and then pick up the load, and then answer the solar panels; Connection operation is important to note that each terminal with indicated on the controller cannot be wrong, plus or minus two polarity can't collision, cannot meet the; Otherwise the controller will be damaged.
5, the debugging system work is normal; Loosen the controller solar panels on the wire, the light; Connected to the solar panel cables, light; Careful observation of each indicator light on the controller changes at the same time; Everything is normal, can seal control box.