Count the five chaos in the energy-saving lamp industry

Counting down the five chaos in the energy-saving lamp industry, compared with traditional lighting appliances, the efficiency is low and the power consumption is high. Energy-saving lamps are increasingly popular with consumers due to their high luminous efficiency, good color rendering, and long life. They have also been welcomed by the Chinese government and others. Vigorous promotion by the national government. However, the relevant agencies of many provinces and cities in China have found that only about 50% of energy-saving lamps meet the national standards during random inspections. Although there may be problems with the limitations of sampling samples, the chaos in the energy-saving lamp market is no secret in the industry.　　 Cut corners and energy efficiency false standard 　　 Since the implementation of the energy efficiency labeling system for energy-saving lamps, energy efficiency false standard has become a new problem. In a recent spot check test conducted by the Beijing Consumers Association, the initial measured value of .% of energy-saving lamps did not reach the stated value of the company's products.　　 'Energy-saving lamps whose initial luminous efficiency is not up to standard are usually cut corners on raw materials, using fake and inferior three-basic toners or mixed powders.' Manager Liu of an energy-saving lamp manufacturer in Shenzhen told '** Finance and Economics Daily.' 'The relative value of energy-saving lamp products is low. Unlike refrigerators, air conditioners and other large appliances that have implemented energy efficiency labeling systems, the industry brand concentration is low. Therefore, the implementation and supervision of energy efficiency labeling systems must be more difficult than large appliances. 'Said Liu Shengping, vice chairman and secretary-general of the China Lighting Association.　　The power does not match the deviation is large　　Beijing Consumers Association test shows that the measured value of .% of the energy-saving lamp power does not reach the stated value of the company's products, even including some well-known brand products. For example, the province gives you the province brand W energy-saving lamp, the measured power is .~.W, and the deviation is .%~.%; the Meiyuan brand W energy-saving lamp, the measured power is .~.W, and the deviation is .%~.%; more The difference between some brand marks and the actual power is nearly doubled. For example, the measured power of the Starfire W energy-saving lamp is .~.W, and the deviation is .%~.%.　　The national standard stipulates that the difference between the actual power consumed by the energy-saving lamp and the rated power shall not be greater than %. Regarding the discrepancy between the power of the energy-saving lamp and the label, Manager Zeng of an energy-saving electrical appliance company in Jiangxi said: “On the one hand, the quality of the electronic components in the circuit is unstable and the design parameters are unreasonable; on the other hand, the company’s production control is not well done, and the product There is no testing when leaving the factory.” 　　 Pseudo-energy saving and sacrificing environmental protection. Due to the inability of some small and medium-sized energy-saving lamp companies to deal with the problem of mercury content in their products, and the lack of a clear recycling system for waste energy-saving lamps in China, many energy-saving lamps have been established. Enterprises are at the cost of polluting the environment. For example, milligrams of mercury infiltrating into the ground will pollute about a ton of water and the surrounding soil, while an ordinary energy-saving lamp contains on average .mg of mercury. 'The feasibility of recycling energy-saving lamps for production enterprises is very low.' Manager Zeng told reporters, 'Waste energy-saving lamps are hazardous waste and cannot be degraded by themselves like some garbage. Special technology is needed from transportation to harmlessness, and the cost is too high. '　　 Small enterprises with multiple production capacity dispersion' U,. Yuan; U,. Yuan; Half spiral. Yuan; Full spiral. Yuan.' This is the price quoted by an energy-saving lamp manufacturer in Zhongshan. 'Regular manufacturers can't produce high-quality energy-saving lamp products at three or five yuan.' Manager Zeng revealed that in order to reduce costs, many small companies use halogen powder or mixed powder that has long been eliminated instead of rare earth three-color phosphors, which can save costs. Yuan~Yuan. In addition, the flame-retardant point of energy-saving lamps is resistant to high temperatures, but many manufacturers use non-flame-retardant plastic parts, and the cost of a lamp can also be saved. Yuan~yuan. Some energy-saving lamps simply save even the insurance tube, or even external Bile lime materials, various electronic components, etc., may use things of different quality to reduce costs. 'For a long time, China's energy-saving lamp industry has been in a fragmented and chaotic pattern. There are many small enterprises, few large enterprises, and the degree of intensification and scale of production is very low.' Liu Shengping told reporters that there are currently tens of thousands of enterprises in the industry, of which large Enterprises accounted for about %, and small and medium-sized enterprises accounted for about %.　　*** OEM Small business is near the brand 　　 China Illuminating Society Mr. Wen told reporters, “Energy-saving lamps have higher technical requirements”, the quality of parts is better, the manufacturing process must be strict, and the inspection methods must be complete, all of which increase the cost. Many companies try to imitate, but usually the core part cannot be imitated.　　 It is understood that due to the low-cost products of small and medium-sized enterprises flooding the market, international energy-saving lamp brand manufacturers have also encountered great pressure when opening up the Chinese market. Some international brand manufacturers simply rent out their brands to domestic manufacturers, which are OEM produced and shipped by domestic manufacturers. However, these ** companies are sometimes not so handy in quality control, so problems may arise.　　 Manager Liu said that at present, there are also some small workshops that are counterfeit and well-known**. These products are usually pieced together with inferior parts to make inferior products. It is difficult for ordinary consumers to distinguish them by using low prices to seize the market. Count the five chaos in the energy-saving lamp industry