Benxi street lamp

With the improvement of economic level, people demand for road lighting at night also subsequently heighten. And high lamp as a large lighting appliances, because of the irradiation range is wide, brightness is good, widely used in outdoor lighting of the project, many areas are now installed high

with the improvement of economic level, people has also increased the demand for road lighting at night. Light, as a kind of large lighting appliances, because of its wide exposure, good brightness and is widely used in outdoor lighting project. Nowadays, high lamp installed in many areas. Light of the actual installation, however, has caused many headaches, they often don't know how to install it correctly. Today, the side will shaw to introduce all the old iron to light, correct installation process.

1 for the one, before the installation. Pay attention to in the process of installation and transportation shock 2. High lamp before the installation, pay attention to shut off the power, so as to avoid improper operation caused by electric shock. 3. If found the lamp body wire damage, immediately cut off the power and stop using it. 4. Check whether the voltage marked on projection lamp is consistent with the input voltage. Installation instructions 1. Will light, 3 core signal lines connected to the controller, the two core is the power cord connected to the switch power supply, do not use waterproof tape wrapped in terminal 2. According to the power and projection lamp power transformer, calculating how much each transformer may be installed a projection lamp 3. Transformer switching power supply is connected to the 220 v power supply goods. Switch control switch power supply by air body and time. Main controller insert the 220 v power supply. 4. High lamp controller installed, first light signal lines connected to the controller signal, each controller can only install a fixed number of led to shoot the light. Installation test: if the led light source of the product quality is bad, such as virtual welding, welding, waterproof processing is not good, should be returned to the high lamp manufacturers. Due to the high lamp installation in the outdoor environment has a great influence on the service life of street lamps, therefore require product is high temperature resistant, and achieve cooling purposes performance standards. Late proposed preliminary product selection to specify brand, to save maintenance cost. If the projection lamp can't normal measurement, please replace the light source of electrical parts, if no problem, then replace the controller, if there is a technical problem, the communication with the manufacturers to solve the problem.

these are the correct high lamp installation process. Installed whether before or after, we all need to pay attention to some matters, in accordance with the procedures and requirements for high lamp installation process correctly.