Battery solar street lamps, and the installation of lamps and lanterns1

As a result of the solar street light energy conservation and environmental protection, and green, pollution-free, so it is very popular in the market, so the installation up to still have some questions need to be aware of, so just follow below small make up together to learn about solar street light when installed on battery and the related introduction of lamps and lanterns.

battery installation

1, when installing the battery, make sure light to take light put, avoid smashed control box.

2, battery cables between the bolts must be used to pressure on the battery terminal, and use of copper gaskets, the use of copper gaskets main purpose is to increase its electrical conductivity, the bigger improve charging efficiency.

3, in the absence of note in the installation, that is, in any case, are not allowed to appear short situation, if there is a short answer, then it will be great cause damage to the battery.

4, the output of the battery line connected to the pole of the controller, must pass through PVC pipes.

5, in the above four steps are completed, be sure to check the relevant controller port connection, short circuit of the aim is to happen. The installation of lamps and lanterns of

1, the installation of lamps and lanterns, the first thing to do is the fixed related components, first of all, the sun plate fixed on the bracket of solar panels, then put the lamp holder is fixed on the pick arm, then stent and pick the arm on the fixed on the main stem, finally the connector back into control box.

2, light pole, check whether the fasteners is strong, before lifting socket installation is correct, officials work is normal, and then in a simple and easy to install after debugging.

3, pay attention to security measures, because this time for the lifting of the tubes, this time to do it is, the Angle of the sun.

4, put battery into battery box, and then according to the relevant technical requirements to connect back to the control box, first to battery, solar panels after load connection again, can't meet the, otherwise the controller will be damaged.

5, and debugging of the whole system, check the system whether can normal work.

the battery solar street lamps and the installation method of lamps and lanterns is probably so, might as well when install can refer to these matters, to ensure the installation quality.