Abstract: in view of the yunnan street lamp installation of solar street lamps with lithium ion batteries

1, according to the actual requirements of the scene environment, and the ways to adjust to the position of the road lights and ballast, ready for the length of the corresponding three core cable. 2, then put the lid on the ballast using a wrench, open the three core cable connected to the ballast to the right. With

1, according to the actual requirements of the scene environment, adjust the location of the lamp and ballast and way, and prepare the corresponding length of the three core cable. 2. And then using a wrench, lifted the lid on the open the ballast will be three core cable connected to the ballast. Specific method is as follows: first, through the ballast output port to the introduction of the cable of the ballast. The cable wire ( Red) And zero line ( Blue) And the ground wire ( Yellow and green) Respectively connected to the ballast 4, 5 and 6 terminal, then tighten the nut. 3. To the preparation of a good three core power cable by introducing ballast ballast input port at the end of the cavity, and then will wire, the zero line and ground wire is connected to the ballast respectively 1, 2, 3 on the location of the terminal, tighten gland nut. 4. Install the cover at the back of the ballast and nut and tighten. Put through power supply. 5. When bulb damaged or need to change, to be on the safe side, we must first cut off power supply, check whether the chain hoist is hang up, and then using a wrench, loosen the bolts on the shell lightly down the lamp body parts, separate the light body and the lamp holder shell, unscrew the old light bulb, install the new bulbs, then open the power supply.