Airport high lamp base generally consists of embedded parts, stirrup, counterpoise, Angle iron, Grounding) Must be made the basis of the above material composition, norms. The selection of embedded parts and dig a hole size 1, general high lamp embedded parts size selection is the caliber + 100 - 150, such as under the light pole diameter is
the airport high lamp base generally consists of embedded parts, stirrup 【 Stirrup: ( 古金) 呼啦圈; Stirrup used to meet shear strength in inclined section and connection for reinforcement and compressive zone mixed bones and muscles of steel. 】 Network, 【 'Net' refers to when the satellite signal failure, temporary Internet receiving signals from the ground, at this point, the log in the advanced Settings should be changed to: radio receiving protocol: TCP, data sending protocol: TCP. 】 , Angle iron, Grounding) Must be made the basis of the above material composition, norms.
the selection of embedded parts and dig a hole size
1, the general high lamp diameter selection is the caliber of embedded object + 100 - 150, such as under the light pole diameter is 500, the embedded parts diameter should be 600 - 650.
2, one over ten of the height of light pole, such as 25 m light pole height of embedded parts of 2. 5M。
3, dug a pit depth for one 7 of the lamp light pole, such as 25 m light pole digging holes dug a pit for about 3. 5 meters ( 15 meters below the conventional calculated on one 8 to one 9) Integration of solar street light prices
4, dig a hole width is generally 3 - of embedded parts size 4 times, such as the diameter of 700 embedded parts have dug a pit width should be 2100 ( Depending on the light pole weight and height adjustment) In commonly 2 to 15 meters and below Three times.
5, generally more than 15 meters of embedded parts shall be provided with decorative flange to prevent deformation of embedded parts, usually 6 - 8 mm thick enough, 150 - in the middle 200 the threading hole line, decorative flange size is consistent with the chassis.