A lamp 11 m what is the price of solar street light

Install solar LED street lamp, solar battery components must first open the solar battery components packing and check for damage to the solar battery components. Put solar battery components guard plate placed on Angle steel box, and then place the solar battery components on the plate;

when installing solar cell components of solar led street lamp, first open the packing box of solar cell components, check whether the solar cell component damage. Then, place the solar energy battery components guard in the frame of the Angle, and then place the solar battery components on guard; When placed the solar cell module, junction box are in high position. When the solar cell module is in horizontal, junction box should be near the lamp module. According to the system voltage level and the solar cell module voltage connect the solar cell module. If the street lamp system voltage is 24 v, the voltage of the solar cell module for 17 v or 18 v, is through the solar cell module should be the first module of the anode ( Or cathode) And the second module of the cathode ( Or anode) Connected in series. If the voltage of the solar cell module is 34 v, the solar cell module should be parallel. Parallel method is the first module of the positive and negative and the second module corresponding to connect the positive and negative. Connection, the junction box with a small screwdriver to open the solar modules, solar cells with small screwdriver component of the power cord on the junction box, red line connecting the anode, cathode blue line connection. Wires, tight junction box outlet waterproof nut, silicone coated with 7091 seal on the box. The amount of glue to make the junction box of the ingate completely sealed, and should be fixed. Multimeter is used to test the solar cell module connection ( Connected to the controller side) Whether the short circuit, is also used to check whether the output voltage of the solar cell module meet the system requirements. In sunny day, open circuit voltage should be greater than 18 v ( System voltage is 12 v) 34 v (or System voltage is 24 v) 。 Installation before and after test, the leakage line core should be connected to the controller of solar energy battery components the power cord is desperately with insulating tape, two layers of insulation tape should be package. Note: during the installation process carefully handle the battery components, tools and other instruments in order to avoid damage. The solar cell module and battery module bracket M6 times; 20 bolts, M6 nut and washer. 6. When installation, bolts should be installed inside extroversion, and then install washer, nut fastening. Tighten bolts, the joint should be connected firmly, no loose. Shandong street lamp lighting factory co. , LTD is a professional manufacturer of solar garden light, solar led street light, the light, the lithium battery solar street lamp, garden lamp, landscape lamp, etc all kinds of street lamp enterprises. , high quality and low price. Welcome new and old customers to come to consult. YWX [ Good quick push screen promotional 18013196696]