6 m solar street lamps landscape lamp several mistakes installation solutions

6 m solar street lamps factory is through the top solar photovoltaic panels absorb sunlight, then converted into electrical energy stored in the storage battery, night again through the battery discharge to power leds for lighting. So 6 meters can normal lighting, solar street light night depends on

6 m solar street lamp manufacturers through the top of the solar photovoltaic panels absorb sunlight, then convert sunlight into electrical energy stored in the battery, then put the battery discharge, provide energy for light emitting diode lamp used for lighting at night. Therefore, 6 m solar street light can be normal lighting at night, depends on solar photovoltaic panels can receive sunlight during the day. If there are too many obstacles around 6 m solar street lights, such as leaves, buildings, etc. Barrier will affect the normal absorption and utilization of the solar surface light source, led to the decrease of the charging power. Treatment plan: 6 m solar street lamp installation should be far away from the shade. If you can't avoid shadows, solar photovoltaic panels should ensure that no shadow of towards the south, perhaps lighting time should not less than 6 hours. In addition to 2 meters or 6 meters long, solar street lamps and other light source. 6 m is still a kind of intelligent street lamp, solar street lamps without human control, can use lighting control adjust the dark days of the four seasons is different. Photovoltaic panels around the lamp, if any photo will be failure, 6 meters long natural solar street lamps can't normal light. Installing a 6 m solar street lights, please stay away from other sources to prevent interference. Deal: if installed 6 m solar street lights, found unable to dismantle the pv panel light source, should be adjusted to time control mode. Third, the solar panels on the indoor batteries. Non-motor vehicle lanes signal in order to save trouble, some customers installing solar lights indoors, such as island in building and car shed, for passing or parking. Although there is a certain light in these places day, they can't meet the requirements of full charge. With the long-term development, cell damage can be completely damaged. Treatment plan: if you want to make 6 meters long enough light, solar street lamps you must move the solar photovoltaic panels to outside. If you have to deal with indoor lighting, you can also choose to charging outdoor and indoor lighting model of separation device. Four, photovoltaic panels to the failure of the device photovoltaic panels need to be well fixed before erect stem. If the photovoltaic panels found in trouble after stem erect, photovoltaic panels can't fully absorb sunlight to charge. Treatment plan: first determine light-emitting diode lighting direction, and then determine the direction of the photovoltaic panels. When installing photovoltaic panels shall be installed in the direction of the sun. In general, it toward the south in China. The installation of different views also affects the power of pv module. Five, not the correct use of remote control some projects construction personnel not correct use of the remote control projects, accidentally pressed it, in order to ensure that will open. In fact, this is a very wrong operation. Fault parameters may be set up on the wrong printer, result in abnormal lighting. Deal: normal manufacturer usually have a professional installation personnel to 6 m solar street lamps of various parameters on the scene to guide and debugging.